Nowadays, people's living standards are getting higher and higher, and some people are more demanding in terms of style when decorating. For example, they like to install light strips on the steps of the stairs. This also has many advantages. and going down the stairs will be very comfortable. It is safe and can also have a decorative effect. So, what should you do when pre-embedding strip lights? What should you pay attention to when installing strip lights? Interested friends may wish to read this article from the editor.
1. How to integrate the stair step light strip
1. First, we need to find the power cord pulled from the corner and then pull that cord down the steps. END. The steps below typically use a 2-0.5 power cord.
2. Cut the step lights and place them on each step, and open several mounting holesscrew into the step socket depending on the length of each step, for example, if it is 1 meter. If it is a step of 1.2. For a 1.2 meter staircase, you need to drive three screws. If it is a 1.2 meter staircase, you need to drive four screws.
3. Place the expansion bolt into the screw hole, then use screws to fix it on the step.
4. Install the cut light strip into the slot of the step light strip, then connect it to the main line along the wire. Finally, install the light strip on the step and secure it.
5. Next, you need to install the step adjustment heads. Place the left and right heads on both sides of the steps, then fix them with expansion screws.
2. Installation precautions
1. The height of stair treads installed at home is generally about 20 cm, while the height of stair treads installed in public places isgenerally between 16 cm and 18 cm. between.
2. The center distance is generally about 25 cm, the smallest cannot exceed 22 cm, and the largest cannot exceed 28 cm.
3. The width of the tread is generally around 80 cm.
4. Before installation, you must first determine the installation length. Generally speaking, you should take an integer to intercept, so as not to affect the circuit and prevent a certain unit from turning on. .
5. The light strips should be laid flat and placed in the light tray after finished.
6. The connection plug has positive and negative poles, so it must be connected correctly during installation and cannot be connected incorrectly, otherwise the plug will not light up.
The above points are the precautions on how to integrate and install stair step light strips. For more informationtions, you can also pay attention to the official website of Qijia.
No.
There will be no electricity leakage if installed correctly. Most LEDs are low voltage light sources. Once normal power is connected, the transformer switches to a low voltage output. If you think the LEDs will leak electricity, any lights installed will lose electricity.
Before installation, you must first determine the installation length. Generally speaking, you should take an integer to intercept, so as not to affect the circuit and prevent a certain unit from turning on. The placement of the light strips must be certain. It must be flat and arranged before placing it in the light tray. The connection plug has positive and negative poles, so it must be connected correctly during installation and cannot be connected incorrectly, otherwise the plug will not connect.will not light up.