In general, individual series are fine-tuned here. All probes in this position are hammer probes. Nowadays, there is a better thermal sensor, which is not easy to break and almost does not need to be replaced. But whatever the type of advice, it is best to ask the manufacturer's after-sales service to do it. After all, they are professionals.
What are the symptoms if the solar probe is broken?
The correct steps to replace the solar water heater probe: First, rotate slowly the old probe out of the solar bucket, then after removing it, cut the old one. When cutting, keep the thread longer, about 30 centimeters is enough. Then dial the wire, then connect each wire of the new probe with the same color as the original. cut the thread, then slowly put it back into the bucket, then add water to see if it can reach 100%. If not, pull the probe out a little, otherwise lower it just a little.
Performance: the water is filled continuously or there is no water, the temperature is not displayed or the water level is not displayed, the temperature is 00 or foggy, etc.
1. Solution:
Just take it out directly, it is fixed with a rubber gasket. It should be replaced with a new one, because the sensor will be affected by water quality, thus shortening its lifespan. Therefore, it is recommended to pay attention to the quality of the sensor when replacing it and not to be greedy. cheap.
2. The functions of solar collectors:
1. Solar water heater is a device that converts solar energy into thermal energy, heating water from low temperature to high temperature to meet people's daily needs. hot water needs in production. Solar water heaters are divided into sub-tube solar water heaterss vacuum and flat solar water heaters depending on their structural shapes. Evacuated tube solar water heaters are mainly used, accounting for 95% of the domestic market share.
2. Household evacuated tube solar water heaters are composed of heat collecting tubes, water storage tanks, brackets and other related parts. The conversion of solar energy into thermal energy mainly relies on vacuum heat collector tubes, which use hot water. to float and cold water to sink. The principle causes the water to produce microcirculation to obtain the required hot water.