No power outage required.
1. If not necessary, disconnect the negative battery terminal and speed sensor harness in the engine compartment. Remove the bolts securing the sensor harness bracket. Pay attention to the installation and positioning of the wiring harness positioning clip. Remove the sensor locating bolt from the front wheel hub. Remove the front wheel speed sensor by lifting it directly from the housing without damaging the sensor contacts. Clean and replace if necessary;
2. Place the sensor in the bracket and install the mounting bolts. Remove the brake caliper and brake rotor. Use a non-ferrous feeler gauge to check the gap between the top of the sensor and the spring wheel. Check this play in several places on the wheel hub. If the gap is too small, use an anti-lock brake system sensor shim to raise the cadapter, remove the sensor, install the shim and recheck. If the gap is too large, check the elastic wheel, hub and sensor for damage.
3. Once the gap is correct, use the correct torque to secure the bolts. On the end of the sensor, install each harness clip and locator. Connect the sensor to the anti-lock brake system wiring harness in the engine compartment.
How to easily replace the solar water heater sensor
The analysis is as follows:
1. There is a rubber stopper which is similar to. the cap of a thermos bottle. Hold the rubber stopper. It swings back and forth and comes off with a pull. When choosing, pay attention to whether there are two or four wires.
2. You can also purchase an instrument set including solenoid valve and sensor online without disassembling the original sensor, which costs only 100 yuan. The sensor can be insertedD in the exhaust hole on the water. tank, and it is very convenient to use.
Like air speed, water speed can also be measured through an orifice plate. However, the main purpose of measuring water flow is to determine heat. There are many types of heat meters on the market capable of measuring flow rates, and the principles vary.
As shown in the figure:
Schematic diagram of the design principle of water flow sensor
Liquid flow rate can be measured through the orifice plate, impeller, ultrasonic and electromagnetic methods
< p>Baidu Encyclopedia: Water flow sensorSolar water heater probes are divided into side versions and lower. The replacement method is the same, buy the same type of probe. Remove the original probe and cut the signal cable connector. Install the new probe and connect the cablesignal. That's it. It is recommended to contact the place where you purchased your solar for after-sales service instead of repairing it yourself. Do-it-yourself maintenance is subject to some failures.