1. The extinguisher switch is not turned on and the extinguisher wire is shorted. Lack of engine oil (models with protector).
2. Sensor: Disconnect the oil sensor cable and replace the oil sensor if the gasoline engine can start.
3. Ignition system problems: Disconnect the spark plug and start the engine without loading, and observe the spark. It is normal for the spark to be white and red if there is no spark, replace the spark. plug or igniter. A single-phase generator (also called a single-phase alternator) is an alternating current electrical generator that produces a single, continuous alternating voltage. Single-phase generators can be used to produce electricity in single-phase electrical systems.
Refers to the car fault display code.
Continuing to drive will cause the vehicle's engine to stall due to insufficient power.The role of the generator in the vehicle is relatively important. It constitutes the main source of energy for the vehicle. It can power all vehicle equipment and can also charge the battery, which is very important. When a motor vehicle's alternator fault light comes on, the vehicle cannot continue to drive.
The vehicle should be driven to a nearby service center or repair shop at a safe speed. If the distance to the after-sales and repair workshop is too great, a trailer will be necessary to transport the vehicle. If the alternator fault light comes on, this indicates that there is a problem with the engine. If the vehicle is forced to roll at this time, it may result in greater vehicle breakdown.
For example:
When the check engine light comes on, it means there is a problem with the engine exhaust system. If it goes outA few seconds after starting the engine, this means a normal system self-test. If it stays on, there may be a problem with the exhaust system. If it lights up flashing, it means the engine is misfiring and damaging the catalytic converter.
When the malfunction indicator light turns on, it means that the current engine system is faulty and requires timely inspection and maintenance. In this case, a preliminary judgment must be made: cut off the anode or cathode of the car. battery and unplug it for a few seconds, then hang it up again after starting the car, see if the instrument can still work normally.