Electric underfloor heating. What are the advantages of electric underfloor heating compared to traditional heating? Compared with traditional heating methods, electric floor heating has obvious advantages: firstly, the room temperature is evenly distributed. Thanks to underfloor heating, the temperature difference in the room is extremely small because the entire floor is evenly distributed thanks to electric underfloor heating. In addition, the indoor temperature gradually decreases from low to high, and the floor temperature is higher than the temperature of the human respiratory system, giving people a comfortable feeling of warm feet and cool head.
Usually, traditional heating methods, especially those burning coal, not only produce a large amount of dust and harmful gases, but also leave a lot of residue, which is neither good nor for the chuman body nor for the environment. Another point is that the cost is relatively high. Electric heating is different: it uses electrical energy and has safe and developed circuits. It will not pollute the environment or affect people's health.
Compared to other heating methods, most electric heating must be laid underground. It is easy to install and the choice of materials needs to be better, as subsequent maintenance etc. is more difficult, so go from there. From one point of view, the cost is not very low. However, electric heating can be used for a long time and the comfort level is particularly high, both from an economic point of view and from a comfort point of view.
Compared to the commonly used water floor heating, electric floor heating is thinner and is very practical for communities with larger floors. At the same time, by rapPort to traditional floor heating, electric floor heating can save about 5% of indoor space.
Electric floor heating installation method:
1. Install the underfloor heating insulation board first to prevent heat from transferring downward. Be sure to clean the floor before installing the insulation board.
2. After installing the insulation board, install the reflective film for underfloor heating. The function of reflective film is to reflect heat upwards.
3. Installing a silicon crystal mesh prevents the heating cable from sinking into the insulating layer after heating. This can also strengthen the cement layer.
4. Lay the heating cables. Please note that the heating cable cannot be cut or spliced at will. It must be laid entirely in a roll, the spacing must therefore be calculated before installation. The method for calculating spacing isa following: installation surface/length of the heating cable.
The installation area here refers to the area where the heating cable is actually installed. For example, if a room is 15 square meters, but there is no sidewalk under the cabinet, then the cabinet area must be deducted. Assuming the cabinet area is 1 square meter, the actual floor space is 14 square meters. Then divide by the length of the cable.