First check whether the gasoline is smooth and the spark is normal
Method: pull out the spark plug directly, block the spark plug hole with your fingers, pull the pull plate several times with one hand, and smell the gasoline smell with your fingers after removing it< /p>
If so, this proves that the circuit of oil is normal. If this is not the case, check the oil circuit (oil switch, carburetor, etc.). Connect the spark plug to the high pressure cap, touch its thread to the bolt or technical part of the body, pull the pull plate and check the spark plug. Are there jumps in sparks? If so, is it normal? If not, check the kill switch, high voltage box, spark plug and other circuits. Also, if you feel impact and suction when you block the spark plug hole with your fingers, if so, it isnormal. , check the valve clearances, if the valve is stuck, etc.
Once these three checks are done or eliminated, it should be able to start normally
Also, if it has a oil alarm, you should check whether the engine oil is sufficient and add an appropriate amount. After using the oil, you can directly disconnect a wire directly under the body to eliminate the oil series fault.
It is not often used and it is difficult to start when He is used. This is because it is not commonly used and as the carburetor oil level drops, rot will occur inside, blocking the oil hole.
Engine oil has returned to the oil pan after a long period of inactivity. When the engine was first started, there was no engine oil lubrication and cylinder pressure could not be achieved. At this time, too much gasoline (cold oil) has not beenburned and the engine oil did not burn. The spark plug is clogged (the plug is wet).
Remove the spark plug, wipe it clean, burn it with a lighter and put it back in, or replace it with a new spark plug.
Why does the Honda car not start?
Ignition system problem, generator component failure.
1. Ignition System Problems: The generator's ignition system is responsible for igniting the fuel. If the ignition system is faulty or damaged, the generator will not operate properly.
2. Generator Component Failure: Generator components such as generator rotor, stator, brushes, etc. are faulty or damaged, which will prevent the generator from producing electricity.
Nine reasons and solutions to the Honda breakdown;
1. The battery is dead. This can happen suddenly, or even while driving, causing the car to break down. IslandIt is possible that the battery life has expired or the battery is dead.
Solution: If the battery life is exhausted, replace it with a new one. If the battery is dead, you need to find someone to turn the ignition on, then let the car idle for ten minutes to charge the battery.
2. The spark plug or ignition coil is damaged or has heavy carbon deposits.
Solution: Go to a 4S workshop or auto repair shop for maintenance.
3. The car's generator is broken.
Solution: This is easy to detect. It is enough to ask the master to test it with an electric meter.
4. Fuel pump pressure relief and insufficient cylinder pressure. This will also cause the phenomenon of not starting a fire.
Solution: Replace the fuel pump.
5. Insufficient engine oil. Sees herure has no source of energy, gasoline, so naturally it cannot start.
SolveMethod: Add gasoline.
6. Incorrect gears can also prevent the car from starting. Generally speaking, when starting with an automatic transmission, P or N is the correct gear. If you are careless and put the equipment in R or other gears, not only will it not start a fire, but it will also cause safety hazards.
Solution: Adjust the speed.
7. The pipeline through which gasoline flows is blocked. When a vehicle starts, it consumes fuel. When the pipes through which gasoline flows are clogged, gasoline cannot be consumed, causing the vehicle to break down.
Solution: Go to the 4S store to replace or clean the pipes.
8. The throttle valve is too dirty, blocking the idle throttle valve hole and makingdifficult start. However, it is easy to get started by pressing the accelerator.
Solution: Go to the repair shop to clean the accelerator.
9. A failure of the water temperature sensor or oxygen sensor can also cause starting difficulties.
Solution: Go to a repair shop to replace the sensor.
One million subsidies for car purchases