How to deal with Hongyan Diamond Generator's failure to produce electricity.
1. There is mud or oxide on the wiring joint between the stator winding and the generator power distribution equipment, the wiring screws are loose, the connection wire is broken, and the stator winding is broken.
2. The rotation speed is too low. Measure the rotation speed and keep it at the nominal value.
3. If the field circuit is disconnected or has poor contact, use a multimeter to find out where the disconnect is, then re-solder the disconnect firmly and wrap it to insulate it.
4. The rectifier tube is damaged. Replace damaged components. If the direction of rotation of the main motor is incorrect, change the direction of rotation of the main motor.
5. The brush holder is rusty and the brush cannot slide up and down. Use an emery cloth to clean the surfboardinner side of the brush holder. If it is damaged, replace it.
6. There is poor contact between the brush and slip ring or insufficient brush pressure. Clean the surface of the slip ring and polish the brush to match the surface of the slip ring to increase the pressure of the brush.