No. The highest point of the piston stroke is a horizontal plane above the cylinder. There is a distance between the piston and the spark plug and they will not touch each other. A gasoline generator is generally composed of a stator, rotor, end cover, bearing and other components. An engine is a machine that converts chemical energy into mechanical energy. Its conversion process is actually a work cycle process.
The main reason is that the spark plug is too dirty. It can be cleaned with gasoline, then adjust the electrode gap to 0.6mm to 0.smm, then dry it and reuse it.
1. Fault phenomenon, causes and troubleshooting methods
1. The spark from the spark plug is very weak or there is no fire.
2. If there is no oil or water in the carburetor, inject gasoline into the carburetor. The engine can start, but it will rarely stall.mps after working.
3. While the engine is running, it slowly stalls.
4. Black smoke comes from the exhaust, but the engine cannot start.
5. The carburetor continues to leak oil.
6. Unscrew the spark plug. The electrode will be wet and smell like gasoline.
7. When starting manually or electrically, you will feel the engine running easily. Once the compression is complete, you still feel that there is very little resistance.
8. The engine has no back pressure and is not easy to ignite and start, but there is a blowing phenomenon in the exhaust pipe.
9. When starting the generator, there is reverse rotation and the carburetor even backfires.
2. Troubleshooting Methods
1. If the engine can start without the ignition switch, the switch is shorted. The ignition switch can be removed for inspection or remlocation.
2. First check the engine oil level. If normal, the oil level alarm device wiring can be removed. If the engine can be started, it means that the oil level alarm device is damaged. and can be removed for repair or replacement.
3. If the spark plug magnet is cracked or the center electrode is corroded and damaged, the spark plug should be replaced.
4. If the spark plug is too dirty, it can be cleaned with gasoline, then adjust the electrode gap to 0.6mm - 0.smm, then dry it and reuse it.
5. Check whether the resistance value of the low voltage coil and the load coil is within its range, or check whether its peak voltage is normal and can be repaired. Otherwise, replace the affected coil or the entire coil. electronic ignition.
6. If the joint between the high voltage wire and the spark plug is not firmlyconnected, you can replace it with a new one. When the high voltage wire becomes wet and leaks electricity, you can do this. remove it, clean it, then dry it. If it is still ineffective after treatment, you should replace it with a new one.