Let’s talk about the generator belt tensioner first. If there is a problem with this tensioner.
When the alternator belt cools the car or the battery loses power,
the alternator belt may make unusual noises. The tensioner pulley will oscillate violently.
There is a problem with the belt tensioner of the second leather of the air conditioner.
Once the compressor is on and empty, it will make a slipping belt noise.
And there will be a gurgling sound in the cabin.
The third timing belt tensioner pulley,
This tensioner pulley is the most important component of the vehicle.
This part should only be replaced regularly when the timing belt is replaced.
If you replace it, there will be no problem.
Or when the battery loses power, the generator belt will make abnormal noise. The tensioner pulley will oscillate violently. There is a problem with thee belt tensioner of the second air conditioner belt. Once the compressor is turned on and empty, a belt slipping noise and gurgling sound will be heard in the cabin.
How long does it take to replace Nissan Teana generator
1 Open the engine hood and find the location of the generator and belt.
2. Use a wrench to loosen the generator's adjustment screw or tensioner to loosen the belt.
3. Remove the original belt and pay attention to the installation position and direction of the belt.
4. Remove the new belt and install the new belt correctly according to the installation position and direction of the original belt.
5. Use a wrench to adjust the generator tensioner and tighten the belt. At the same time, pay attention to the tightness of the belt. Don't be too tight or too loose.
6. Start the engine and see ifthe belt operates normally. If there is any abnormal noise or beating, stop the vehicle immediately to check or readjust the belt tension.
7. Close the engine cover and check if it is firmly seated and if the belt is installed correctly.
Nissan AltimaReplacing the alternator takes 20 to 30 minutes.
Replacing the generator is quick. Loosen the fan belt, remove the generator adjustment bolts, remove the generator wiring (remember the color of the wires to avoid incorrect connections during installation), remove the generator bracket bolts, remove the old generator and tap the new generator. Just install the opposite. program.
It usually takes no more than 30 minutes, and the fastest only takes 20 minutes. It depends on the skill of the repairer. If it is difficult to remove the bOh well, this won't be over for several years. hours.