As one of the most important parts, the generator can be repaired by taking appropriate measures if it is not producing electricity.
If the generator is not producing electricity, you can also judge this by checking the two voltage regulator wires. Generally, one wire is the positive pole output and the other wire is the positive pole output. output of the excitation wire. We can check if the two regulator wires are connected correctly or use a multimeter to check if the regulator is working properly.
Precautions when using the alternator:
1. Frequently clean dirt and dust from the exterior of the generator and keep it clean and well ventilated.
2. Frequently check the tightening conditions of the generator-related fasteners and tighten the screws in time.
3. The tension of the drive belt must be appropriate. If he istoo loose, it will slip easily and result in insufficient power production; if it is too tight, it will easily damage the belt and generator bearings.
4. When installing the battery, be careful not to install it incorrectly. Usually, install the positive wire first and not the ground wire, otherwise the diode will burn out easily.
5. When using an integrated circuit regulator, the ignition switch should be turned off immediately when the engine is not running.
6. It is never allowed to use the “scratching” method to test whether electricity should be produced.
7. When the generator fails to generate electricity, it must be eliminated in time, otherwise it will cause a more serious breakdown.