The miner's lamp has two voltage supplies, 12V and 6V
Usage and operation methods of the miner's lamp
1. Charging method
This type of the miner's lamp provides two charging methods, that is, using the unique lithium battery miner's lamp intelligent charger (KLZC-001) and the battery holder. intelligent charging of lithium battery miner's lamp (KCLA-24, KCLA-48, KCLA-60, KCLA-102) designed and produced by our company to match this type of miner's lamp) to charge.
The charging input voltage of the miner's lamp is 4.9-10V.
The above two charging devices are equipped with power indicators. power and charge status. When charging this type of miner's lamp, turn on the above charging equipment. At this time, the power indicator of the charging equipment lights green. If the power indicator does not respond, please check si the power outlet. the charging equipment is in good contact. After the charging device is turned on, install the miner's lamp head on the power base. If the miner's lamp battery is low, the charging device's charge status light will turn red. If the miner's lamp is fully charged, the charging status indicator on the charging device will display green and it can be used after maintaining a trickle charge for 1-2 hours. Normal charging time does not exceed 10 hours.
2. Normal use method
Before using the miner's lamp for the first time (new miner's lamp), the method provided in 4.1 should be used to charge the miner's lamp until the battery is safely full.
Note: The power switch of the miner's lamp must be turned off when charging. A charger approved by our company must be usedfor loading.
When using this type of miner's lamp, the hook on the rear is usually installed directly onto the lamp holder on the front of a standard miner's helmet. When installed, the lampshade is forward, and the switch on the left side of the lamp head is the power switch. Turn the switch clockwise to be the main light source and turn it counterclockwise to be the auxiliary light source. The main light source can guarantee a lighting time of more than 15 hours, and the auxiliary light source can maintain a lighting time of more than 20 hours.