Step One: Connect your own mesh bag and water line to both outlet ends of the fish trap;\r\n 1. How to connect the mesh bag: The ring where the mesh bag is connected to the output line must be conductive. Good conductors (like copper and aluminum rings, steel rings are not very good in general, the net ring diameter is better around 16cm (you can decide according to the size of the fish) .is too small, floating fish will not be caught, too big fish will escape easily\r\n 2. How to connect the water pipe: It is better to connect the water pipe to one wire. coated copper or aluminum wire with better conductivity The wire diameter is preferably larger. Remove a bare wire of about 50. -90 cm and slide it under water (the image. shows a stripped wire with a diameter of 1 cm or approximately 0.75 square meters and50 cm stretched). \r\n 3. Finally, I would like to remind everyone that the water line and the mesh bag should not be connected upside down. The positive pole of the fish device output is connected to the mesh bag, and the negative pole is connected to. the water pipe. Because fish all have positive tendencies, if the fish is poorly connected, it will swim in the opposite direction of the mesh bag and will not be able to catch the floating fish. \r\nStep 2: Find the corresponding outlet and plug in the manual switch or foot switch. There is nothing to explain about this. \r\nStep 3: Connect the input ends of the fish device to the battery or lithium battery, respectively. Some fish machines are equipped with 12 V and some are equipped with 24 V. We must understand this clearly from the trader before purchasing the machine. The two ends of the input cannot be connected backwards. The positive polef of the fish machine is connected to the positive pole of the power supply, and the negative pole is connected to the negative pole. If you buy a machine without reverse connection protection, the fish machine will be burned if you press the switch when connected reversely. However, there are fish traps. If they are connected backwards, they will not work. . No matter how they are connected, they will not burn. \r\nStep 4: Press the switch of the fish trap to start working. \r\nStep 5: It should be noted that when the machine is working, do not touch the outlet ends of the fish trap with both hands at the same time to avoid accidents.
How to wire a fish trap?
Introduction How to wire a fish trap? Step 1: Connect your own mesh bag and water line to the two outlet ends of the fish trap respectively; \r\n 1. How to connect the mesh bag: the ring where the mesh bag is connected to the outlet line;