|
SIST ISO 11088:2018
01-oktober-2018
1DGRPHãþD
SIST ISO 11088:2011
6LVWHPVPXþLYH]LþHYOML6%% ]DDOSVNRVPXþDQMH6HVWDYOMDQMHQDVWDYLWHYLQ
QDG]RU
Alpine ski/binding/boot (S-B-B) system -- Assembly, adjustment and inspection
Ensemble ski/fixation/chaussure (SFC) pour skis alpins -- Montage, réglage et contrôle
Ta slovenski standard je istoveten z: ISO 11088:2018
ICS:
97.220.20 Oprema za zimske športe Winter sports equipment
SIST ISO 11088:2018 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ISO 11088:2018
---------------------- Page: 2 ----------------------
SIST ISO 11088:2018
INTERNATIONAL ISO
STANDARD 11088
Sixth edition
2018-05
Alpine ski/binding/boot (S-B-B)
system — Assembly, adjustment and
inspection
Ensemble ski/fixation/chaussure (SFC) pour skis alpins — Montage,
réglage et contrôle
Reference number
ISO 11088:2018(E)
©
ISO 2018
---------------------- Page: 3 ----------------------
SIST ISO 11088:2018
ISO 11088:2018(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: [email protected]
Website: www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved
---------------------- Page: 4 ----------------------
SIST ISO 11088:2018
ISO 11088:2018(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle . 3
5 Skier's parameters . 3
5.1 General . 3
5.2 Weight method . 3
6 Equipment parameters . 3
6.1 Choice of new equipment . 3
6.2 Visual inspection and preparation of used equipment . 3
6.3 Assembly . 4
6.4 Binding-to-boot fitting adjustments . 4
6.5 Initial indicator adjustment .
...