|
-- -
INTERNATIONAL STANDARD IS0 8473:1988
TECHNICAL CORRIGENDUM I
Published 1992-12-1 5
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION. M EXAYHAPOflHAR OPrAHM3A4MR Il0 CTAHAAPTM3AuMM. ORGANISATION INTERNATIONALE DE NORMALISATION
INTERNATIONAL ELECTROTECHNICAL COMMISSION MEMAYHAPOAHAR 3flEKTPOTEXHMqECKAR KOMMCCMR . COMMISSION ELECTROTECHNIOUE INTERNATIONALE
Information processing systems - Data communications -
Protocol for providing the connectionless-mode network
service
TECHNICAL CORRIGENDUM 1
Systèmes de traitement de l'information - Communications de données - Protocole fournissant le service de réseau en
mode sans connexion
RECTIFICATIF TECHNIQUE 1
Technical corrigendum 1 to International Standard IS0 8473:1988 was prepared by Joint Technical Committee
ISO/IEC JTC 1, Information technology.
Page 3
Subclause 3.7.6
Line 2, delete the words "or all".
Page 6
Subclause 5.6
Table 3, add the following entry.
.Cancel S-Name,
UDC 681.327.8.01 Ref. No. IS0 8473:1988/Cor.l:1992 (El
Descriptors : data processing, information interchange, network interconnection, communication procedure, control procedures,
programming (computers), instructions (computers).
O ISO/IEC1992
Printed in Switzerland
---------------------- Page: 1 ----------------------
IS0 8473: 1988/Cor. 1 : 1992 (E)
Then move the entire text of subclause 5.6, with the exception of the first sentence (which begins "A ti service shall be
provided."), including the amended table 3, to annex A, replacing all of the existing subclause A.3.3 ex for the heading
and the first sentence of the subclause.
Page 8
Subclause 6.5
ie phrase "using
Lines 4 and 5, replace the phrase "using the Destination Address and Total Length fields of the PDU" wi
(if the Segment
the Destination Address field and either the Segment Length field (if present) or the Total Length fi
Length field is not present)".
Page 9
Subclause 6.7
:he words "with
In the definition of segment offset, replace the words "with respect to the start of the Initial PDU" w
respect to the start of the Data Part of the Initial PDU".
Subclause 6.8
of item a); and
In note 2 at the end of the clause, delete item c); move the word "or" from the end of item b) to the
remove the semicolon at the end of item b). Replace the text of note 3 with the following:
"The originator of the Initial PDU determines the value of the Segmentation Permitted flag in the Initial and all Derived
PDUs (if any). An intermediate system may not change this value in the Initial PDU or any PDU derived 1 I it, and may not
therefore add or remove the segmentation part of the header."
Page 10
Subclause 6.9
Add the follo
...