|
SIST ENV 1317-4:2002
01-september-2002
2SUHPDFHVWGHO5D]UHGLXSRUDEQRVWLPHULOD]DSUHVNXãDQMHREQDOHWXLQ
SUHVNXVQHPHWRGH]D]DNOMXþQLFHLQSUHKRGQHHOHPHQWHYDUQRVWQLKRJUDM
Road restraint systems - Part 4: Performance classes, impact test acceptance criteria
and test methods for terminals and transitions of safety barriers
Rückhaltesysteme an Straßen - Teil 4: Leistungsklassen, Abnahmekriterien für
Anprallprüfungen und Prüfverfahren für Anfangs-, End- und Übergangskonstruktionen
von Schutzeinrichtungen
Dispositifs de retenue routiers - Partie 4: Classes de performance, criteres d'acceptation
des essais de choc et méthodes d'essai des extrémités et raccordements des glissieres
de sécurité
Ta slovenski standard je istoveten z: ENV 1317-4:2001
ICS:
13.200 3UHSUHþHYDQMHQHVUHþLQ Accident and disaster control
NDWDVWURI
93.080.30 Cestna oprema in pomožne Road equipment and
naprave installations
SIST ENV 1317-4:2002 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ENV 1317-4:2002
---------------------- Page: 2 ----------------------
SIST ENV 1317-4:2002
EUROPEAN PRESTANDARD
ENV 1317-4
PRÉNORME EUROPÉENNE
EUROPÄISCHE VORNORM
November 2001
ICS 13.200; 93.080.30
English version
Road restraint systems - Part 4: Performance classes, impact
test acceptance criteria and test methods for terminals and
transitions of safety barriers
Dispositifs de retenue routiers - Partie 4: Classes de Rückhaltesysteme an Straßen - Teil 4: Leistungsklassen,
performance, critères d'acception des essais de choc et Abnahmekriterien für Anprallprüfungen und Prüfverfahren
méthodes d'essai des extrémités et raccordements des für Anfangs-, End- und Übergangskonstruktionen von
glissières de sécurité Schutzeinrichtungen
This European Prestandard (ENV) was approved by CEN on 30 September 2001 as a prospective standard for provisional application.
The period of validity of this ENV is limited initially to three years. After two years the members of CEN will be requested to submit their
comments, particularly on the question whether the ENV can be converted into a European Standard.
CEN members are required to announce the existence of this ENV in the same way as for an EN and to make the ENV available promptly
at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in parallel to the ENV) until the final
decision about the possible conversion of the ENV into an EN is reached.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2001 CEN All rights of exploitation in any form and by any means reserved Ref. No. ENV 1317-4:2001 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST ENV 1317-4:2002
ENV 1317-4:2001 (E)
Contents
page
Foreword .3
Introduction .4
1 Scope.4
2 Normative references.4
3 Abbreviations .5
4 Terms and definitions.5
5 Terminals.7
6 Transitions . 14
7 Test methods . 16
Bibliography. 21
2
---------------------- Page: 4 ----------------------
SIST ENV 1317-4:2002
ENV 1317-4:2001 (E)
Foreword
This European Prestandard has been prepared by Technical Committee CEN/TC 226 "Road
equipment", the secretariat of which is held by AFNOR.
This European Prestandard u
...