|
STANDARDSIST EN 10264-3:20031DGRPHãþD
SIST EN 10264-3:2012
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 10264-3
January 2012 ICS 77.140.65 Supersedes EN 10264-3:2002English Version
Steel wire and wire products - Steel wire for ropes - Part 3: Round and shaped non alloyed steel wire for high duty applications
Fils et produits tréfilés en acier - Fils pour câbles - Partie 3: Fils ronds et profilés, en acier non aillé, pour fortes sollicitations
Stahldraht und Drahterzeugnisse - Stahldraht für Seile - Teil 3: Runder und profilierter Draht aus unlegiertem Stahl für hohe Beanspruchungen This European Standard was approved by CEN on 19 November 2011.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2012 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 10264-3:2012: ESIST EN 10264-3:2012
EN 10264-3:2012 (E) 2 Contents Page Foreword .31 Scope .42 Normative references .43 Designation of the product .54 General conditions of manufacture .55 Characteristics of the wire .55.1 Tensile strength grades .55.2 Profiles .65.2.1 Definition of shaped wire .65.2.2 Equivalent diameter .85.3 Minimum requirements for wire characteristics .85.3.1 Dimension – measured values .85.3.2 Reverse bend test .95.3.3 Torsion test . 125.3.4 Zinc and Zn95/Al5 coatings .
...