|
STANDARD
SIST EN 300 440-2 V1.3.1:2009
ETSI EN 300 440-2 V1.3.1 (2009-03)Harmonized European Standard (Telecommunications series) Electromagnetic compatibilityand Radio spectrum Matters (ERM);Short range devices;Radio equipment to be usedin the 1 GHz to 40 GHz frequency range;Part 2: Harmonized EN covering essential requirementsof article 3.2 of the R&TTE Directive SIST EN 300 440-2 V1.3.1:2009
ETSI ETSI EN 300 440-2 V1.3.1 (2009-03) 2
Reference REN/ERM-TG28-0426-2 Keywords radio, regulation, SRD, testing ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00
Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88
Important notice Individual copies of the present document can be downloaded from: http://www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http://portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: http://portal.etsi.org/chaircor/ETSI_support.asp Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2009. All rights reserved.
DECTTM, PLUGTESTSTM, UMTSTM, TIPHONTM, the TIPHON logo and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. LTE™ is a Trade Mark of ETSI currently being registered for the benefit of its Members and of the 3GPP Organizational Partners. GSM and the GSM logo are Trade Marks registered and owned by the GSM Association. SIST EN 300 440-2 V1.3.1:2009
ETSI ETSI EN 300 440-2 V1.3.1 (2009-03) 3 Contents Intellectual Property Rights . 5 Foreword . 5 Introduction . 5 1 Scope . 6 2 References . 7 2.1 Normative references . 7 2.2 Informative references . 7 3 Definitions, symbols and abbreviations . 8 3.1 Definitions . 8 3.2 Symbols . 8 3.3 Abbreviations . 8 4 Technical requirements specifications . 8 4.1 Environmental profile . 8 4.2 Conformance requirements . 8 4.2.1 Transmitter requirements . 8 4.2.1.1 Equivalent isotropically radiated power . 8 4.2.1.2 Permitted range of operating frequencies . 9 4.2.1.3 Unwanted emissions in the spurious domain . 9 4.2.1.4 Duty cycle . 9 4.2.2 Receiver requirements . 9 4.2.2.1 Adjacent channel selectivity. 9 4.2.2.2 Blocking or desensitization . 9 4.2.2.3 Spurious radiations . 9 4.2.3 2,45 GHz RFID systems . 9 4.2.4 GBSAR systems . 9 4.2.4.1 Effective radiated power . 9 4.2.4.2 Permitted range of operating frequencies . 10 4.2.4.3 DAA threshold . 10 4.2.4.3.1 DAA timing parameters. 10 4.2.4.4 Antenna pattern . 10 4.2.4.5 Unwanted emissions in the spurious domain . 10 5 Testing for compliance with technical requirements . 10 5.1 Description of testing for compliance with technical requirements . 10 5.1.1 Environmental conditions for testing . 10 5.1.1.1 Normal and extreme test-conditions. 11 5.1.1.2 Test power source . 11 5.1.2 Choice of samples for test suites . 11 5.2 Interpretation of the measurement results . 11 5.3 Essential transmitter test suites . 11 5.3.1 Equivalent isotropically radiated power . 11 5.3.2 Permitted range of operation frequencies . 11 5.3.3 Unwanted emissions in the spurious domain . 12 5.4 Essential receiver test suites . 12 5.4.1 Adjacent channel selectivity . 12 5.4.2 Blocking or desensitization . 12 5.4.3 Spurious radiations . 12 5.5 Tests for RFID systems at 2,45 GHz . 12 5.6 Tests for GBSAR systems . 12 5.6.1 Effective radiated power . 12 5.6.2 Permitted range of operating frequencies . 12 5.6.3 DAA threshold . 12 5.6.4 DAA timing parameters . 13 5.6.4.1 Minimum listen time . 13 SIST EN 300 440-2 V1.3.1:2009
ETSI ETSI EN 300 440-2 V1.3.1 (2009-03) 4 5.6.4.2 Minimum listen time after detection . 13 5.6.4.3 Maximum transmitter on-time . 13 5.6.4.4 Minimum transmitter off-time . 13 5.6.5 Antenna pattern . 13 5.6.6 Unwanted emissions in the spurious domain . 13 Annex A (normative): HS Requirements and conformance Test specifications Table (HS-RTT) . 14 Annex B (informative): The EN title in the official languages . 16 History . 17
SIST EN 300 440-2 V1.3.1:2009
ETSI ETSI EN 300 440-2 V1.3.1 (2009-03) 5 Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http://webapp.etsi.org/IPR/home.asp). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Harmonized European Standard (Telecommunications series) has been produced by ETSI Technical Committee Electromagnetic compatibility and Radio spectrum Matters (ERM). The present document includes improvements to the previous version of the standard that take advantage of technical developments within the SRD industry. In particular this includes optional features such as Listen Before Talk (LBT) and Detect And Avoid (DAA). The present document has been produced by ETSI in response to a mandate from the European Commission issued under Council Directive 98/34/EC (as amended) [i.1] laying down a procedure for the provision of information in the field of technical standards and regulations. The present document is intended to become a Harmonized Standard, the reference of which will be published in the Official Journal of the European Communities referencing the Directive 1999/5/EC [i.2] of the European Parliament and of the Council of 9 March 1999 on radio equipment and telecommunications terminal equipment and the mutual recognition of their conformity ("the R&TTE Directive"). Technical specifications relevant to Directive 1999/5/EC [i.2] are given in annex A. The present document is part 2 of a multi-part deliverable covering Electromagnetic compatibility and Radio spectrum Matters (ERM); Short range devices; Radio equipment to be used in the 1 GHz to 40 GHz frequency range, as identified below: Part 1: "Technical characteristics and test methods"; Part 2: "Harmonized EN covering essential requirements of article 3.2 of the R&TTE Directive".
National transposition dates Date of adoption of this EN: 18 March 2009 Date of latest announcement of this EN (doa): 30 June 2009 Date of latest publication of new National Standard or endorsement of this EN (dop/e):
31 December 2009 Date of withdrawal of any conflicting National Standard (dow): 31 December 2010
Introduction The present document is part of a set of standards developed by ETSI and is designed to fit in a modular structure to cover all radio and telecommunications terminal equipment within the scope of the R&TTE Directive [i.2]. The modular structure is shown in EG 201 399 [i.4]. SIST EN 300 440-2 V1.3.1:2009
ETSI ETSI EN 300 440-2 V1.3.1 (2009-03) 6 1 Scope The present document applies to the following Short Range Device major equipment types: 1) Generic Short Range Devices, including alarms, telecommand, telemetry, data transmission in general, etc.; 2) Radio Frequency IDentification (RFID); 3) Radiodetermination, including detection, movement and alert applications. These radio equipment types are capable of operating in the permitted frequency bands within the 1 GHz to 40 GHz range as specified in table 1: • either with a Radio Frequency (RF) output connection and dedicated antenna or with an integral antenna; • for all types of modulation; • with or without speech. Table 1 shows a list of the frequency bands as designated by the European Commission Decisions on Short Range Devices [i.6], [i.7] and the CEPT/ERC/REC 70-03 [i.3] as known at the date of publication of the present document. Table 1: Short Range Devices within the 1 GHz to 40 GHz frequency band
Frequency Bands Applications Notes Transmit and Receive 2 400 MHz to 2 483,5 MHz Generic use
Transmit and Receive 2 400 MHz to 2 483,5 MHz Detection, movement and alert applications
Transmit and Receive (a) 2 446 MHz to 2 454 MHz RFID See annex C of EN 300 440-1 [1] Transmit and Receive (b) 2 446 MHz to 2 454 MHz RFID See annex C of EN 300 440-1 [1] Transmit and Receive 5 725 MHz to 5 875 MHz Generic use
Transmit and Receive 9 200 MHz to 9 500 MHz Radiodetermination: radar, detection, movement and alert applications
Transmit and Receive 9 500 MHz to 9 975 MHz Radiodetermination: radar, detection, movement and alert applications
Transmit and Receive 10,5 GHz to 10,6 GHz Radiodetermination: radar, detection, movement and alert applications
Transmit and Receive 13,4 GHz to 14,0 GHz Radiodetermination: radar, detection, movement and alert applications
Transmit and Receive 17,1 GHz to 17,3 GHz Radiodetermination: GBSAR detection, movement and alert applications See annex E of EN 300 440-1 [1] Transmit and Receive 24,00 GHz to 24,25 GHz Generic use and for
Radiodetermination: radar, detection, movement and alert applications
NOTE: (a) and (b) refer to two different operational restrictions for different power levels in the same frequency band.
NOTE 1: It should be noted that table 1 represents the most widely implemented position within the European Union [i.6], [i.7] and the CEPT countries [i.3], but it should not be assumed that all designated bands are available in all countries. NOTE 2: In addition, it should be noted that other frequency bands may be available in a country within the frequency range 1 GHz to 40 GHz covered by the present document. See the European Commission Decisions on Short Range Devices [i.6], [i.7] and the CEPT ERC Recommendation 70-03 [i.3] as implemented through National Radio Interfaces (NRI) and additional NRI as relevant. SIST EN 300 440-2 V1.3.1:2009
ETSI ETSI EN 300 440-2 V1.3.1 (2009-03) 7 NOTE 3: On non-harmonized parameters, national administrations may impose certain conditions such as the type of modulation, frequency, channel/frequency separations, maximum transmitter radiated power, duty cycle, and the inclusion of an automatic transmitter shut-off facility, as a condition for the issuing of an Individual Rights for use of spectrum or General Authorization, or as a condition for use “under licence exemption”, as it is in most cases for Short Range Devices. The present document covers fixed stations, mobile stations and portable stations. Applications using Ultra Wide Band (UWB) technology are not covered by the present document. The present document does not require measurements for radiated emissions below 25 MHz. The present document is intended to cover the provisions of article 3.2 of Directive 1999/5/EC [i.2] (R&TTE Directive). The present
...