|
STANDARDSIST EN 12521:20101DGRPHãþD
SIST EN 12521:2016
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 12521
December
t r s w ICS
{ yä s v r Supersedes EN
s t w t sã t r r {English Version
Furniture æ Strengthá durability and safety æ Requirements for domestic tables Mobilier æ Résistanceá durabilité et sécurité æ Exigences relatives aux tables à usage domestique
Möbel æ Festigkeitá Dauerhaltbarkeit und Sicherheit æ Anforderungen an Tische im Wohnbereich This European Standard was approved by CEN on
z November
t r s wä
egulations which stipulate the conditions for giving this European Standard the status of a national standard without any alterationä Upætoædate lists and bibliographical references concerning such national standards may be obtained on application to the CENæCENELEC Management Centre or to any CEN memberä
translation under the responsibility of a CEN member into its own language and notified to the CENæCENELEC Management Centre has the same status as the official versionsä
CEN members are the national standards bodies of Austriaá Belgiumá Bulgariaá Croatiaá Cyprusá Czech Republicá Denmarká Estoniaá Finlandá Former Yugoslav Republic of Macedoniaá Franceá Germanyá Greeceá Hungaryá Icelandá Irelandá Italyá Latviaá Lithuaniaá Luxembourgá Maltaá Netherlandsá Norwayá Polandá Portugalá Romaniaá Slovakiaá Sloveniaá Spainá Swedená Switzerlandá Turkey andUnited Kingdomä
EUROPEAN COMMITTEE FOR STANDARDIZATION COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre:
Avenue Marnix 17,
B-1000 Brussels
9
t r s w CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Membersä Refä Noä EN
s t w t sã t r s w ESIST EN 12521:2016
EN 12521:2015 (E) 2 Contents Page European foreword . 3 1 Scope . 4 2 Normative references . 4 3 Terms and definitions . 4 4 Test conditions and test sequence . 4 5 Safety requirements . 5 5.1 General . 5 5.2 Shear and squeeze points . 5 5.2.1 Shear and squeeze points when setting up and folding . 5 5.2.2 Shear and squeeze points under influence of powered mechanisms . 5 5.2.3 Shear and squeeze points during use . 5 5.3 Stability . 5 5.3.1 Stability under vertical load . 5 5.3.2 Stability for tables with extension elements . 6 6 Stability, strength and durability . 6 6.1 General . 6 6.2 Strength and durability requirements . 7 7 Information for use .
...