|
SIST ISO 24487-1:2023
01-april-2023
Grafična tehnologija - Ofsetne plošče brez razvijanja - 1. del: Metode ocenjevanja
lastnosti in uporabnosti
Graphic technology — Processless lithographic plates — Part 1: Evaluation methods for
characteristics and performance
Technologie graphique — Plaques lithographiques sans traitement — Partie 1:
Méthodes d'évaluation des caractéristiques et des performances
Ta slovenski standard je istoveten z: ISO 24487-1:2021
ICS:
37.100.10 Reprodukcijska oprema Reproduction equipment
SIST ISO 24487-1:2023 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ISO 24487-1:2023
---------------------- Page: 2 ----------------------
SIST ISO 24487-1:2023
INTERNATIONAL ISO
STANDARD 24487-1
First edition
2021-11
Graphic technology — Processless
lithographic plates —
Part 1:
Evaluation methods for characteristics
and performance
Technologie graphique — Plaques lithographiques sans traitement —
Partie 1: Méthodes d'évaluation des caractéristiques et des
performances
Reference number
ISO 24487-1:2021(E)
© ISO 2021
---------------------- Page: 3 ----------------------
SIST ISO 24487-1:2023
ISO 24487-1:2021(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2021
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: [email protected]
Website: www.iso.org
Published in Switzerland
ii
© ISO 2021 – All rights reserved
---------------------- Page: 4 ----------------------
SIST ISO 24487-1:2023
ISO 24487-1:2021(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Test procedure .2
4.1 General . 2
4.2 Test environment . 2
4.3 Plate imaging . 2
4.4 Pre-dampening amount . . 4
4.5 Pre-inking amount . 4
4.6 Ink selection . 4
4.7 Substrate selection. 4
4.8 Fountain solution .
...