|
STANDARDSIST EN 13244-5:2003SIST EN 12201-5:20031DGRPHãþD
SIST EN 12201-5:2011
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 12201-5
September 2011 ICS 23.040.01 Supersedes EN 12201-5:2003, EN 13244-5:2002English Version
Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 5: Fitness for purpose of the system
Systèmes de canalisations en plastique pour l'alimentation en eau et pour branchements et les collecteurs d'assainissement avec pression - Polyéthylène (PE) - Partie 5 : Aptitude à l'emploi du système
Kunststoff-Rohrleitungssysteme für die Wasserversorgung und für Entwässerungs- und Abwasserdruckleitungen - Polyethylen (PE) - Teil 5: Gebrauchstauglichkeit des Systems This European Standard was approved by CEN on 8 July 2011.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2011 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 12201-5:2011: ESIST EN 12201-5:2011
EN 12201-5:2011 (E)
2 Contents Page Foreword . 3Introduction . 41Scope . 52Normative references . 53Terms and definitions, symbols and abbreviations . 64Fitness for purpose of the system . 64.1Method of preparation of assemblies for testing . 64.1.1General . 64.1.2Butt fusion joints . 74.1.3Electrofusion joints. 74.1.4Mechanical joints . 74.2Requirements for fitness for purpose . 74.2.1General .
...