|
STANDARD
SIST EN 302 217-2-2 V1.3.1:2009
ETSI EN 302 217-2-2 V1.3.1 (2009-04)Harmonized European Standard (Telecommunications series) Fixed Radio Systems;Characteristics and requirements forpoint-to-point equipment and antennas;Part 2-2: Digital systems operating in frequency bands wherefrequency co-ordination is applied;Harmonized EN covering the essential requirementsof article 3.2 of the R&TTE Directive
SIST EN 302 217-2-2 V1.3.1:2009
ETSI ETSI EN 302 217-2-2 V1.3.1 (2009-04) 2
Reference REN/ATTM-04004 Keywords antenna, DFRS, digital, DRRS, FWA, point-to-point, radio, regulation, transmission ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00
Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88
Important notice Individual copies of the present document can be downloaded from: http://www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http://portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: http://portal.etsi.org/chaircor/ETSI_support.asp Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2009. All rights reserved.
DECTTM, PLUGTESTSTM, UMTSTM, TIPHONTM, the TIPHON logo and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. LTE™ is a Trade Mark of ETSI currently being registered for the benefit of its Members and of the 3GPP Organizational Partners. GSM and the GSM logo are Trade Marks registered and owned by the GSM Association. SIST EN 302 217-2-2 V1.3.1:2009
ETSI ETSI EN 302 217-2-2 V1.3.1 (2009-04) 3
Contents Intellectual Property Rights.7 Foreword.7 Introduction.7 1 Scope.9 1.1 General background.9 1.2 Spectral efficiency classes.9 1.3 System alternatives.10 1.4 Channel arrangements and utilization.10 1.5 Payload flexibility.10 1.6 Document structure.11 2 References.12 2.1 Normative references.12 2.2 Informative references.13 3 Definitions, symbols and abbreviations.15 3.1 Definitions.15 3.2 Symbols.15 3.3 Abbreviations.16 4 Technical requirements specifications.16 4.1 Environmental profile.16 4.2 Transmitter requirements.17 4.2.1 Transmitter power.17 4.2.2 Transmitter power and frequency control.17 4.2.2.1 Transmitter Power Control (ATPC and RTPC).17 4.2.2.1.1 Automatic Transmit Power Control (ATPC).18 4.2.2.1.2 Remote Transmit Power Control (RTPC).18 4.2.2.2 Remote Frequency Control (RFC).18 4.2.3 Transmitter power tolerance.18 4.2.4 Radio Frequency (RF) spectrum mask.18 4.2.4.1 Limits background.18 4.2.4.2 Limits.21 4.2.5 Discrete CW components exceeding the spectrum mask limit.22 4.2.5.1 Discrete CW components at the symbol rate.22 4.2.5.2 Other discrete CW components exceeding the spectrum mask limit.22 4.2.6 Spurious emissions - external.23 4.2.7 Dynamic Change of Modulation Order.24 4.2.8 Radio frequency tolerance.24 4.3 Receiver requirements.24 4.3.1 Spurious emissions - external.24 4.3.2 BER as a function of receiver input signal level RSL.24 4.3.3 Co-channel "external" and adjacent channel interference sensitivity.25 4.3.4 CW spurious interference.25 4.4 Antenna directional requirements.26 4.4.1 Radiation Pattern Envelope (Off-axis EIRP density).26 4.4.2 Antenna gain.26 4.4.3 Antenna Cross-Polar Discrimination (XPD).26 5 Testing for compliance with technical requirements.26 5.1 Environmental conditions for testing.26 5.2 Essential radio test suites for the transmitter.27 5.2.1 Transmitter power.28 5.2.2 Transmitter power and frequency control.28 5.2.2.1 Transmitter Power Control (ATPC and RTPC).28 5.2.2.1.1 ATPC.28 5.2.2.1.2 RTPC.29 SIST EN 302 217-2-2 V1.3.1:2009
ETSI ETSI EN 302 217-2-2 V1.3.1 (2009-04) 4
5.2.2.1.3 Remote Frequency Control (RFC).29 5.2.3 Transmitter power tolerance.29 5.2.4 RF spectrum mask.29 5.2.5 Discrete CW components exceeding the spectrum mask limit.29 5.2.6 Spurious emissions - external.29 5.2.7 Dynamic Change of Modulation Order.30 5.2.8 Radio frequency tolerance.30 5.3 Essential radio test suites for the receiver.30 5.3.1 Spurious emissions - external.31 5.3.2 BER as a function of receiver input signal level (RSL).31 5.3.3 Co-channel "external" and adjacent channel interference sensitivity.31 5.3.4 CW spurious interference.32 5.4 Additional essential antenna test suites for systems with integral antenna.32 5.4.1 Radiation Pattern Envelope (Off-axis EIRP density).32 5.4.2 Antenna gain.32 5.4.3 Antenna Cross-Polar Discrimination (XPD).32 Annex A (normative): Frequency bands from 1,4 GHz to 2,7 GHz.33 A.1 Introduction.33 A.2 General characteristics.33 A.2.1 Frequency characteristics and channel arrangements.33 A.2.2 Transmission capacities.34 A.3 Transmitter.34 A.3.1 General requirements.34 A.3.2 Spectrum mask.35 A.4 Receiver.35 A.4.1 General requirements.35 A.4.2 BER as a function of receiver input signal level (RSL).35 A.4.3 Co-channel "external" and adjacent channels interference sensitivity.36 Annex B (normative): Frequency bands from 3 GHz to 11 GHz (channel separation up to 30 MHz and 56/60 MHz).37 B.1 Introduction.37 B.2 General characteristics.37 B.2.1 Frequency characteristics and channel arrangements.37 B.2.2 Transmission capacities.39 B.3 Transmitter.41 B.3.1 General requirements.41 B.3.2 RF spectrum masks.41 B.4 Receiver.44 B.4.1 General requirements.44 B.4.2 BER as a function of Receiver input Signal Level (RSL).44 B.4.3 Co-channel "external" and adjacent channel interference sensitivity.46 Annex C (normative): Frequency bands from 3 GHz to 11 GHz (channel separation 40 MHz).47 C.1 Introduction.47 C.2 General characteristics.47 C.2.1 Frequency characteristics and channel arrangements.47 C.2.2 Transmission capacities.48 C.3 Transmitter.48 C.3.1 General requirements.48 C.3.2 RF spectrum masks.48 C.4 Receiver.49 SIST EN 302 217-2-2 V1.3.1:2009
ETSI ETSI EN 302 217-2-2 V1.3.1 (2009-04) 5
C.4.1 General requirements.49 C.4.2 BER as a function of Receiver input Signal Level (RSL).49 C.4.3 Co-channel "external" and adjacent channel interference sensitivity.50 Annex D (normative): Frequency bands 13 GHz, 15 GHz and 18 GHz.51 D.1 Introduction.51 D.2 General characteristics.51 D.2.1 Frequency characteristics and channel arrangements.51 D.2.2 Transmission capacities.52 D.3 Transmitter.54 D.3.1 General requirements.54 D.3.2 RF spectrum masks.54 D.4 Receiver.57 D.4.1 General requirements.57 D.4.2 BER as a function of Receiver input Signal Level (RSL).57 D.4.3 Co-channel "external" and adjacent channel interference sensitivity.59 Annex E (normative): Frequency bands from 23 GHz to 55 GHz.60 E.1 Introduction.60 E.2 General characteristics.60 E.2.1 Frequency characteristics and channel arrangements.60 E.2.2 Transmission capacities.61 E.3 Transmitter.63 E.3.1 General requirements.63 E.3.2 RF spectrum masks.63 E.3.2.1 Systems E.1, E.2, E.3 and E.4.64 E.3.2.2 Systems E.5, E.6 and E.7.66 E.4 Receiver.67 E.4.1 General requirements.67 E.4.2 BER as a function of Receiver input Signal Level (RSL).67 E.4.2.1 Systems E.1, E.2, E.3 and E.4.68 E.4.2.2 Systems E.7, E.5 and E.6.69 E.4.3 Co-channel "external" and adjacent channel interference sensitivity.70 Annex F (normative): Transmission of packet data and combinations of other signals in bands from 3 GHz to 55 GHz.71 F.1 Introduction.71 F.2 General characteristics.71 F.2.1 Frequency characteristics and channel arrangements.71 F.2.2 Transmission capacities.71 F.3 System parameters.72 F.3.1 Transmitter.72 F.3.2 Receiver.72 F.3.3 FER as a function of BER.72 Annex G (normative): Test report in relation to flexible systems applications.73 G.1 Wide radio-frequency band covering units.73 G.2 Multirate/multiformat equipment.75 G.3 BER measurement in a SDH multi-interface, multi-carrier system.75 G.3.1 Case 1: multi-interface 2 × STM-1/single carrier or multi-interface, 4 × STM-1/two-carrier systems where each STM-1 payload is transmitted on one carrier only.75 G.3.2 Case 2: single interface, STM-4/two-carrier system.76 SIST EN 302 217-2-2 V1.3.1:2009
ETSI ETSI EN 302 217-2-2 V1.3.1 (2009-04) 6
G.3.3 Case 3: multi-interface 4 × STM-1/two-carrier system where each STM-1 payload is transmitted on both carriers.76 Annex H (normative): HS Requirements and conformance Test specifications Table (HS-RTT).77 Annex I (informative): Spectrum mask requirements when power control (ATPC and/or RTPC) or mixed-mode operation are concerned.79 I.1 ATPC impact.79 I.2 RTPC Impact.80 I.3 Mixed-mode operation impact.81 I.3.1 Basic concepts.81 I.3.2 Implications on frequency co-ordination and possible regulatory background (licensing and fee).82 I.3.3 Impact on article 3.2 "essential" parameters and operating conditions.83 Annex J (informative): Typical interference sensitivity behaviour for frequency planning purpose.86 Annex K (informative): The EN title in the official languages.87 Annex L (informative): Bibliography.88 History.89
SIST EN 302 217-2-2 V1.3.1:2009
ETSI ETSI EN 302 217-2-2 V1.3.1 (2009-04) 7
Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http://webapp.etsi.org/IPR/home.asp). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Harmonized European Standard (Telecommunications series) has been produced by ETSI Technical Committee Access, Terminals, Transmission and Multiplexing (ATTM). The present document has been produced by ETSI in response to a mandate from the European Commission issued under Council Directive 98/34/EC [i.2] (as amended) laying down a procedure for the provision of information in the field of technical standards and regulations. The present document is intended to become a Harmonized Standard, the reference of which will be published in the Official Journal of the European Communities referencing the Directive 1999/5/EC [1] of the European Parliament a
...