|
STANDARD
SIST EN 3218-005:2009
EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 3218-005April 2006ICS 49.060 English VersionAerospace series - Connectors, rectangular, with metallic shellsand screw-locking - Part 005: Plug with non-removable size 22solder contacts - Product standardSérie aérospatiale - Connecteurs rectangulaires à boîtiersmétalliques et à verrouillage par vis - Partie 005 : Ficheavec contacts à braser, taille 22, non démontables - Normede produitLuft- und Raumfahrt - Rechtecksteckverbinder mitmetallischem Gehäuse und Schraubverriegelung - Teil 005:Freier Steckverbinder mit Lötkontakten, Größe 22, nichtlösbar - ProduktnormThis European Standard was approved by CEN on 27 February 2006.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the Central Secretariat or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the officialversions.CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania,Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2006 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 3218-005:2006: ESIST EN 3218-005:2009
EN 3218-005:2006 (E) 2 Contents Page Foreword.3 1 Scope.4 2 Normative references.4 3 Terms and definitions.4 4 Required characteristics.4 4.1 Dimensions and masses.4 4.2 Materials and surface finishing.5 4.3 Main general characteristics.5 5 Designation.6 6 Marking.
...