|
STANDARDSIST EN 200:20051DGRPHãþD
SIST EN 200:2009
EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 200July 2008ICS 91.140.70Supersedes EN 200:2004
English VersionSanitary tapware - Single taps and combination taps for watersupply systems of type 1 and type 2 - General technicalspecificationRobinetterie sanitaire - Robinets simples et mélangeurspour les systèmes d'alimentation type 1 et type 2 -Spécifications techniques généralesSanitärarmaturen - Auslaufventile und Mischbatterien fürWasserversorgungssysteme vom Typ 1 und Typ 2 -Allgemeine technische SpezifikationThis European Standard was approved by CEN on 15 June 2008.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the CEN Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as theofficial versions.CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2008 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 200:2008: ESIST EN 200:2009
EN 200:2008 (E) 2
Contents Page Foreword.5 Introduction.6 1 Scope.7 2 Normative references.11 3 Designation.11 4 Marking and identification.12 5 Materials.13 6 Dimensional characteristics.14 7 Sequence of testing.24 8 Leaktightness characteristics.25 9 Pressure resistance characteristics - mechanical performance under pressure.31 10 Hydraulic characteristics.33 11 Mechanical strength characteristics - torsion test for operating mechanism.36 12 Mechanical endurance characteristics.37 13 Backflow protection.45 14 Acoustic characteristics.45 Annex A (informative)
Pressure t
...