|
SIST ISO 7241:2015
01-april-2015
1DGRPHãþD
SIST ISO 7241-1:1997
Fluidna tehnika - Mere in zahteve za hitre cevne spojke
Hydraulic fluid power - Dimensions and requirements of quick-action couplings
Transmissions hydrauliques - Dimensions et exigences des raccords rapides
Ta slovenski standard je istoveten z: ISO 7241:2014
ICS:
23.100.40 Cevna napeljava in sklopke Piping and couplings
SIST ISO 7241:2015 en,fr
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ISO 7241:2015
---------------------- Page: 2 ----------------------
SIST ISO 7241:2015
INTERNATIONAL ISO
STANDARD 7241
First edition
2014-07-15
Hydraulic fluid power — Dimensions
and requirements of quick-action
couplings
Transmissions hydrauliques — Dimensions et exigences des raccords
rapides
Reference number
ISO 7241:2014(E)
©
ISO 2014
---------------------- Page: 3 ----------------------
SIST ISO 7241:2015
ISO 7241:2014(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2014
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [email protected]
Web www.iso.org
Published in Switzerland
ii © ISO 2014 – All rights reserved
---------------------- Page: 4 ----------------------
SIST ISO 7241:2015
ISO 7241:2014(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Dimensional requirements . 2
5 Performance requirements . 7
6 Additional requirements for Series A quick-action couplings for use in agricultural
machinery applications . 8
6.1 General . 8
6.2 Connecting and disconnecting . 8
6.3 Fluid loss . 8
6.4 Valve performance . 8
7 Workmanship . 9
8 Designation . 9
9 Marking .
...