|
STANDARDSIST EN 12392:20021DGRPHãþD
SIST EN 12392:2016
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 12392
March
t r s x ICS
y yä s w rä s r Supersedes EN
s t u { tã t r r rEnglish Version
Aluminium and aluminium alloys æ Wrought products and cast products æ Special requirements for products intended for the production of pressure equipment Aluminium et alliage d 5aluminium æ Produits corroyés et moulés æ Exigences particulières pour les produits destinés à la fabrication des appareils à pression
Aluminium und Aluminium Legierungen æ Knetæ und Gusserzeugnisse æ Besondere Anforderungen an Erzeugnisse für die Fertigung von Druckgeräten This European Standard was approved by CEN on
s z January
t r s xä
egulations which stipulate the conditions for giving this European Standard the status of a national standard without any alterationä Upætoædate lists and bibliographical references concerning such national standards may be obtained on application to the CENæCENELEC Management Centre or to any CEN memberä
translation under the responsibility of a CEN member into its own language and notified to the CENæCENELEC Management Centre has the same status as the official versionsä
CEN members are the national standards bodies of Austriaá Belgiumá Bulgariaá Croatiaá Cyprusá Czech Republicá Denmarká Estoniaá Finlandá Former Yugoslav Republic of Macedoniaá Franceá Germanyá Greeceá Hungaryá Icelandá Irelandá Italyá Latviaá Lithuaniaá Luxembourgá Maltaá Netherlandsá Norwayá Polandá Portugalá Romaniaá Slovakiaá Sloveniaá Spainá Swedená Switzerlandá Turkey andUnited Kingdomä
EUROPEAN COMMITTEE FOR STANDARDIZATION COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre:
Avenue Marnix 17,
B-1000 Brussels
9
t r s x CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Membersä Refä Noä EN
s t u { tã t r s x ESIST EN 12392:2016
EN 12392:2016 (E) 2 Contents Page European foreword . 4 1 Scope . 6 2 Normative references . 6 3 Terms and definitions . 9 4 Materials . 10 4.1 General. 10 4.2 Wrought products . 11 4.3 Cast products . 11 5 Technical conditions for inspection and delivery . 11 5.1 Manufacturing methods . 11 5.1.1 General. 11 5.1.2 Specific requirements regarding porthole extruded and/or drawn products . 11 5.1.3 Quality control . 12 5.2 Orders or tenders .
...