|
SIST ISO 14635-1:2002
01-julij-2002
Zobniki - FZG potek preskušanja - 1. del: FZG metoda preskušanja A/8, 3/90 za
relativno nosilnost olj glede na toplotno razjedanje
Gears -- FZG test procedures -- Part 1: FZG test method A/8,3/90 for relative scuffing
load-carrying capacity of oils
Engrenages -- Méthodes d'essai FZG -- Partie 1: Méthode FZG A/8,3/90 pour évaluer la
capacité de charge au grippage des huiles
Ta slovenski standard je istoveten z: ISO 14635-1:2000
ICS:
21.200 Gonila Gears
SIST ISO 14635-1:2002 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ISO 14635-1:2002
---------------------- Page: 2 ----------------------
SIST ISO 14635-1:2002
INTERNATIONAL ISO
STANDARD 14635-1
First edition
2000-06-01
Gears — FZG test procedures —
Part 1:
FZG test method A/8,3/90 for relative
scuffing load-carrying capacity of oils
Engrenages — Méthodes d'essai FZG —
Partie 1: Méthode FZG A/8,3/90 pour évaluer la capacité de charge au
grippage des huiles
Reference number
ISO 14635-1:2000(E)
©
ISO 2000
---------------------- Page: 3 ----------------------
SIST ISO 14635-1:2002
ISO 14635-1:2000(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not
be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this
file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this
area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters
were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event
that a problem relating to it is found, please inform the Central Secretariat at the address given below.
© ISO 2000
or by any means, electronic
or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body
in the country of the requester.
ISO copyright office
Case postale 56 � CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 734 10 79
E-mail [email protected]
Web www.iso.ch
Printed in Switzerland
ii © ISO 2000 – All rights reserved
---------------------- Page: 4 ----------------------
SIST ISO 14635-1:2002
ISO 14635-1:2000(E)
Contents Page
Foreword.iv
Introduction.v
1 Scope .1
2 Normative references .1
3 Terms and definitions .2
4 Brief description of method.2
4.1 General principle.2
4.2 Precision.4
5 Test materials.4
5.1 Test gears.4
5.2 Cleaning fluid .4
6 Apparatus .6
6.1 FZG spur-gear test rig .6
6.2 Heating device.
...