|
SIST ISO 3548-3:2015
01-marec-2015
1DGRPHãþD
SIST ISO 6524:2002
Drsni ležaji - Tankostene ležajne blazinice s prirobnico ali brez nje - 3. del:
Merjenje dolžine na obodu
Plain bearings - Thin-walled half bearings with or without flange - Part 3: Measurement of
peripheral length
Paliers lisses - Demi-coussinets minces à collerette ou sans collerette - Partie 3:
Mesurage de la longueur développée
Ta slovenski standard je istoveten z: ISO 3548-3:2012
ICS:
21.100.10 Drsni ležaji Plain bearings
SIST ISO 3548-3:2015 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ISO 3548-3:2015
---------------------- Page: 2 ----------------------
SIST ISO 3548-3:2015
INTERNATIONAL ISO
STANDARD 3548-3
First edition
2012-12-01
Plain bearings — Thin-walled half
bearings with or without flange —
Part 3:
Measurement of peripheral length
Paliers lisses — Demi-coussinets minces à collerette ou sans collerette —
Partie 3: Mesurage de la longueur développée
Reference number
ISO 3548-3:2012(E)
©
ISO 2012
---------------------- Page: 3 ----------------------
SIST ISO 3548-3:2015
ISO 3548-3:2012(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2012
or by any
means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the
address below or ISO’s member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [email protected]
Web www.iso.org
Published in Switzerland
ii © ISO 2012 – All rights reserved
---------------------- Page: 4 ----------------------
SIST ISO 3548-3:2015
ISO 3548-3:2012(E)
Contents Page
Foreword .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols . 2
5 Purpose of checking . 3
6 Checking methods . 4
6.1 Method A . 4
6.2 Method B . 4
7 Choice and designation of checking method . 5
7.1 Choice of checking method . 5
7.2 Designation of checking method . 6
8 Measuring equipment . 6
9 Measuring equipment requirements . 8
9.1 General .
...