|
STANDARD 52926-1
First edition
2023-11
Additive manufacturing of metals —
Qualification principles —
Part 1:
General qualification of operators
Fabrication additive de métaux — Principes de qualification —
Partie 1: Qualification générale des opérateurs
Reference number
ISO/ASTM 52926-1:2023(E)
© ISO/ASTM International 2023
---------------------- Page: 1 ----------------------
ISO/ASTM 52926-1:2023(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO/ASTM International 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester. In the United States, such requests should be sent to ASTM International.
ISO copyright office ASTM International
CP 401 • Ch. de Blandonnet 8 100 Barr Harbor Drive, PO Box C700
CH-1214 Vernier, Geneva West Conshohocken, PA 19428-2959, USA
Phone: +41 22 749 01 11 Phone: +610 832 9634
Fax: +610 832 9635
Email: [email protected] Email: [email protected]
Website: www.iso.org Website: www.astm.org
Published in Switzerland
ii
© ISO/ASTM International 2023 – All rights reserved
---------------------- Page: 2 ----------------------
ISO/ASTM 52926-1:2023(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Operator qualification .2
4.1 General . 2
4.2 Essential variables and the range of qualification . 2
4.2.1 General . 2
4.2.2 The various AM processes for metal . 2
4.2.3 The various feedstock types and material groups . 2
4.2.4 The various types of AM machines . 3
4.3 Assessment principles . 3
5 Qualification test certificate . 4
6 Validity of testing .4
6.1 General . 4
6.2 Conditions of validity . . 5
6.3 Re-qualification test .
...