|
STANDARD 52908
First edition
2023-11
Additive manufacturing of metals —
Finished part properties — Post-
processing, inspection and testing of
parts produced by powder bed fusion
Fabrication additive de métaux — Propriétés des pièces finies — Post-
traitement, inspection et essais des pièces produites par fusion sur lit
de poudre
Reference number
ISO/ASTM 52908:2023(E)
© ISO/ASTM International 2023
---------------------- Page: 1 ----------------------
ISO/ASTM 52908:2023(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO/ASTM International 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester. In the United States, such requests should be sent to ASTM International.
ISO copyright office ASTM International
CP 401 • Ch. de Blandonnet 8 100 Barr Harbor Drive, PO Box C700
CH-1214 Vernier, Geneva West Conshohocken, PA 19428-2959, USA
Phone: +41 22 749 01 11 Phone: +610 832 9634
Fax: +610 832 9635
Email: [email protected] Email: [email protected]
Website: www.iso.org Website: www.astm.org
Published in Switzerland
ii
© ISO/ASTM International 2023 – All rights reserved
---------------------- Page: 2 ----------------------
ISO/ASTM 52908:2023(E)
Contents Page
Foreword .v
Introduction . vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 Abbreviations . 2
5 Qualification . 2
5.1 General . 2
5.2 Part validation . 3
5.3 Technical documentation relating to part(s) produced . 3
5.4 Facility documentation . 3
5.4.1 Additive manufacturer documentation requirements . 3
5.4.2 Subcontractor documentation requirements . 3
5.5 Quality assurance documentation . 4
6 Post processing . 4
6.1 General . 4
6.2 Post-build activities .
...