|
STANDARD 17607-5
First edition
2023-12
Steel structures — Execution of
structural steelwork —
Part 5:
Welding
Structures en acier – Exécution des charpentes et ossatures en
acier —
Partie 5: Soudage
Reference number
ISO 17607-5:2023(E)
© ISO 2023
---------------------- Page: 1 ----------------------
ISO 17607-5:2023(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: [email protected]
Website: www.iso.org
Published in Switzerland
ii
© ISO 2023 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 17607-5:2023(E)
Contents Page
Foreword .v
Introduction . vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 3
4 Execution specification and quality requirements . 3
5 Constituent products . 3
5.1 General . 3
5.2 Welding consumables . 4
5.3 Stud welding . 4
6 Welding . 4
6.1 General . 4
6.2 Welding plan . 5
6.2.1 Requirements for a welding plan . 5
6.2.2 Content of a welding plan . 5
6.3 Welding processes . 5
6.4 Qualification of welding procedures and welding personnel . 6
6.4.1 Qualification of welding procedures . 6
6.4.2 Welders and welding operators . 7
6.4.3 Welding coordination .
...