|
Standard
ISO/ASTM 52909
Second edition
Additive manufacturing of
2024-02
metals — Finished part properties
— Orientation and location
dependence of mechanical
properties for metal parts
Fabrication additive de métaux — Propriétés des pièces finies
— Dépendance de l'orientation et de l'emplacement sur les
propriétés mécaniques pour les pièces métalliques
Reference number
ISO/ASTM 52909:2024(en) © ISO/ASTM International 2024
---------------------- Page: 1 ----------------------
ISO/ASTM 52909:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO/ASTM International 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester. In the United States, such requests should be sent to ASTM International.
ISO copyright office ASTM International
CP 401 • Ch. de Blandonnet 8 100 Barr Harbor Drive, PO Box C700
CH-1214 Vernier, Geneva West Conshohocken, PA 19428-2959, USA
Phone: +41 22 749 01 11 Phone: +610 832 9634
Fax: +610 832 9635
Email: [email protected] Email: [email protected]
Website: www.iso.org Website: www.astm.org
Published in Switzerland
© ISO/ASTM International 2024 – All rights reserved
ii
---------------------- Page: 2 ----------------------
ISO/ASTM 52909:2024(en)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
3.1 Definition .2
3.2 Abbreviations .2
3.3 Acronyms .2
4 Summary of document . 3
5 Significance and use . 3
6 Procedure . 4
7 Report . 4
7.1 General .4
7.2 Additional requirements .4
Annex A (informative) Example raster (scan) strategies for reporting . 5
Bibliogra
...