|
Standard
ISO 8605
Third edition
Fibre-reinforced plastics — Sheet
2024-03
moulding compound (SMC) —
Requirements and specifications
Plastiques renforcés de fibres — Préimprégnés en feuille SMC —
Exigences et spécifications
Reference number
ISO 8605:2024(en) © ISO 2024
---------------------- Page: 1 ----------------------
ISO 8605:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: [email protected]
Website: www.iso.org
Published in Switzerland
© ISO 2024 – All rights reserved
ii
---------------------- Page: 2 ----------------------
ISO 8605:2024(en)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 Classification of SMC . 3
4.1 General .3
4.2 Classification based on composition .3
4.2.1 Resin (matrix) .3
4.2.2 Reinforcement(s) .4
4.2.3 Modes of reinforcement .4
4.2.4 Fillers .5
4.2.5 Additives .5
4.3 Classification based on shrinkage behaviour .5
4.3.1 General-purpose SMC .5
4.3.2 Low-shrinkage SMC .6
4.3.3 Low-profile SMC .6
4.3.4 Class A SMC.6
5 Designation of SMC . 6
5.1 General .
...