|
Standard
ISO 15610
Third edition
Specification and qualification of
2024-03
welding procedures for metallic
materials — Qualification based on
tested welding consumables
Descriptif et qualification d'un mode opératoire de soudage pour
les matériaux métalliques — Qualification basée sur des produits
consommables soumis à essais
Reference number
ISO 15610:2024(en) © ISO 2024
---------------------- Page: 1 ----------------------
ISO 15610:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: [email protected]
Website: www.iso.org
Published in Switzerland
© ISO 2024 – All rights reserved
ii
---------------------- Page: 2 ----------------------
ISO 15610:2024(en)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 2
3 Terms and definitions . 2
4 Limits of the application of this document . 2
4.1 Limits related to the welded joint .2
4.1.1 Parent material .2
4.1.2 Parent material thickness, t .3
4.1.3 Fillet weld throat thickness, a .3
4.2 Limits common to all welding processes .3
4.2.1 Multiple-process welding procedures .3
4.2.2 Welding positions .3
4.2.3 Welding consumables .3
4.2.4 Type of current .3
4.3 Limits specific for the welding process .3
4.3.1 Processes 131, 132, 133, 135, 136 and 138 .3
4.3.2 Processes 141 and 15 .3
4.3.3 Process 121 .
...