|
Standard
ISO 8575
Third edition
Aerospace series — Fluid systems
2024-03
— Hydraulic system tubing
Série aérospatiale — Systèmes de fluides — Tubes pour systèmes
hydrauliques
Reference number
ISO 8575:2024(en) © ISO 2024
---------------------- Page: 1 ----------------------
ISO 8575:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: [email protected]
Website: www.iso.org
Published in Switzerland
© ISO 2024 – All rights reserved
ii
---------------------- Page: 2 ----------------------
ISO 8575:2024(en)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Requirements . 1
4.1 General .1
4.2 Pressure lines .2
4.2.1 Tubing material.2
4.2.2 Tube sizes .2
4.2.3 Qualification .2
4.3 Suction and return lines .2
4.3.1 Tubing material.2
4.3.2 Tube sizes .2
Annex A (informative) Aerospace hydraulic tubing materials . 8
Bibliography . 9
© ISO 2024 – All rights reserved
iii
---------------------- Page: 3 ----------------------
ISO 8575:2024(en)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out through
ISO technical committees. Each mem
...