|
Standard
ISO 19085-6
Second edition
Woodworking machines — Safety —
2024-04
Part 6:
Single spindle vertical moulding
machines (toupie)
Machines à bois — Sécurité —
Partie 6: Toupies monobroches à arbre vertical
Reference number
ISO 19085-6:2024(en) © ISO 2024
---------------------- Page: 1 ----------------------
ISO 19085-6:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: [email protected]
Website: www.iso.org
Published in Switzerland
© ISO 2024 – All rights reserved
ii
---------------------- Page: 2 ----------------------
ISO 19085-6:2024(en)
Contents Page
Foreword .vi
Introduction .vii
1 Scope . 1
2 Normative references . 2
3 Terms and definitions . 2
4 Safety requirements and measures for controls . 9
4.1 Safety and reliability of control systems.9
4.2 Control devices .9
4.3 Start .10
4.3.1 Direct start .10
4.3.2 Start via control power-on .10
4.4 Safe stops .11
4.4.1 General .11
4.4.2 Normal stop .11
4.4.3 Operational stop .11
4.4.4 Emergency stop .11
4.5 Braking function of tools .11
4.6 Mode selection .11
4.7 Tool speed ch
...