|
Standard
ISO 7151
Third edition
Surgical instruments — Non-cutting,
2024-04
articulated instruments — General
requirements and test methods
Instruments chirurgicaux — Instruments articulés, non
tranchants — Spécifications générales et méthodes d'essai
Reference number
ISO 7151:2024(en) © ISO 2024
---------------------- Page: 1 ----------------------
ISO 7151:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: [email protected]
Website: www.iso.org
Published in Switzerland
© ISO 2024 – All rights reserved
ii
---------------------- Page: 2 ----------------------
ISO 7151:2024(en)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Material. 1
5 Requirements . 2
5.1 Heat, treatment and hardness for component parts, excluding rivets and screws and
part manufactures of material grade i .2
5.1.1 Heat treatment .2
5.1.2 Hardness of instruments .2
5.1.3 Hardness of tungsten carbide inserts .2
5.2 Corrosion resistance .2
5.2.1 General .2
5.2.2 Test for resistance to copper sulfate .2
5.2.3 Test for resistance to boiling water .2
5.3 Workmanship .2
5.4 Surface condition .3
5.4.1 General .3
5.4.2 Surface finish .
...