|
Standard
ISO/ASTM 52928
First edition
Additive manufacturing of metal —
2024-05
Feedstock materials — Powder life
cycle management
Fabrication additive de métaux — Matières premières — Gestion
du cycle de vie de la poudre
Reference number
ISO/ASTM 52928:2024(en) © ISO/ASTM International 2024
---------------------- Page: 1 ----------------------
ISO/ASTM 52928:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO/ASTM International 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester. In the United States, such requests should be sent to ASTM International.
ISO copyright office ASTM International
CP 401 • Ch. de Blandonnet 8 100 Barr Harbor Drive, PO Box C700
CH-1214 Vernier, Geneva West Conshohocken, PA 19428-2959, USA
Phone: +41 22 749 01 11 Phone: +610 832 9634
Fax: +610 832 9635
Email: [email protected] Email: [email protected]
Website: www.iso.org Website: www.astm.org
Published in Switzerland
© ISO/ASTM International 2024 – All rights reserved
ii
---------------------- Page: 2 ----------------------
ISO/ASTM 52928:2024(en)
Contents Page
Foreword .v
Introduction .vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols and abbreviations . 2
5 Powder properties . 3
5.1 General .3
5.2 Particle size distribution .3
5.2.1 General .3
5.2.2 Dynamic image analysis .4
5.2.3 Laser diffraction and light scattering .4
5.2.4 Dry sieving .5
5.2.5 Light or scanning electron microscopy (SEM) images .5
5.3 Chemical composition .5
5.3.1 General .5
5.3.2 Combustion methods.
...