|
Standard
ISO 11611
Third edition
Protective clothing for use in
2024-06
welding and allied processes
Vêtements de protection utilisés pendant le soudage et les
techniques connexes
Reference number
ISO 11611:2024(en) © ISO 2024
---------------------- Page: 1 ----------------------
ISO 11611:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: [email protected]
Website: www.iso.org
Published in Switzerland
© ISO 2024 – All rights reserved
ii
---------------------- Page: 2 ----------------------
ISO 11611:2024(en)
Contents Page
Foreword .v
Introduction .vii
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 General and design requirements . . 5
4.1 General .5
4.2 Protective clothing.5
4.3 Size designation and fit .5
4.4 Additional protective garments .5
4.5 Pockets and flap closures . .6
4.6 Closures and seams .6
4.7 Hardware .6
5 Sampling and pre-treatment . . 6
5.1 Sampling .6
5.1.1 General .6
5.1.2 Sampling procedure on fabric materials for the UV transmission measurement .7
5.2 Pre-treatment of material .8
5.3 Ageing .
...