|
_i -
IS0
I NTERN AT1 O NA L ORGAN IZATl ON FOR STAN DA RD IZATlO N
IS0 RECOMMENDATION
R 341
COTTON SPINNING MACHINERY
WORKING WIDTH
1 st EDITION
September 1963
COPYRIGHT RESERVED
The copyright of IS0 Recommendations and IS0 Standards
belongs to IS0 Member Bodies. Reproduction of these
documents, in any country, may be authorized therefore only
by the national standards organization of that country, being
a member of ISO.
For each individual country the only valid standard is the national standard of that country.
Printed in Switzerland
Also issued in French and Russian. Copies to be obtained through the national standards organizations.
---------------------- Page: 1 ----------------------
BRIEF HISTORY
The IS0 Recommendation R 341, Cotton Spinning Machinery- Working Width, was drawn
up by Technical Committee ISO/TC 72, Textile Machinery and Accessories, the Secretariat of
which is held by the Association Suisse de Normalisation (SNV).
Work on this question by the Technical Committee began in 1955 and led, in 1960, to the
adoption of a Draft IS0 Recommendation.
In August 1961, this Draft IS0 Recommendation (No. 445) was circulated to all the IS0
Member Bodies for enquiry. It was approved by the following Member Bodies:
Australia G
...