|
IS0
I NTE R N AT1 ON AL
O RG A N I Z AT1 O N FO R S TA N DA R D I Z AT1 O N
IS0 RECOMMENDATION
R 481
WARPER’S BEAMS
BASIC DIMENSIONS
1st EDITION
April 1966
COPYRIGHT RESERVED
The copyright of IS0 Recommendations and IS0 Standards
belongs to IS0 Member Bodies. Reproduction of these
documents, in any country, may be authorized therefore oniy
by the national standards organization of that country, being
a member of ISO.
For each individual country the oniy valid standard is the national standard of that country.
Printed in Switzerland
Also issued in French and Russian. Copies to be obtained through the national standards organizations.
---------------------- Page: 1 ----------------------
BRIEF HISTORY
The Recommendation ISO/R 481, Warper’s Beams -Basic Dimensions, was drawn up by
Technical Committee ISO/TC 72, Textile Machinery and Accessories, the Secretariat of which is
held by the Association Suisse de Normalisation (SNV).
Work on this question by the Technical Committee began in 1959 and led, in 1962, to the
adoption of a Draft IS0 Recommendation.
In September 1963, this Draft IS0 Recommendation (No. 603) was circulated to all the
IS0 Member Bodies for enquiry. It was approved by the following Member Bodies :
Brazil Italy Spain
Czechoslovakia Japan Switzerland
France Netherlands Turkey
Hungary New Zealand United Kingdom
India Poland Yugoslavia
Two Member Bodies opposed the approval of the Draft:
Germany, U.S.S.R.
The Draft IS0 Recommendation was then submitted by correspon
...