|
Ref. No.: IS0 / R 582 - 1967 (E)
IS0
FOR STAND AR D I Z AT I O N
I NT ERN AT I ON AL ORGAN I ZAT I O N
IS0 RECOMMENDATION
4
R 582
ROLLING BEARINGS
TOLERANCES
METRIC SERIES BEARINGS
CHAMFER DIMENSION LIMITS
AND MAXIMUM SHAFT AND HOUSING FILLET RADIUS
1 st EDITION
July 1967
COPYRIGHT RESERVED
The copyright of IS0 Recommendations and IS0 Standards
belongs to IS0 Member Bodies. Reproduction of these
documents, in any country, may be authorized @herefore only
by the national standards organization of that country, being
a member of ISO.
For each individual country the oniy valid standard is the national standard of that country.
Printed in Switzerland
Also issued in French and Russian. Copies to be obtained through the national standards organizations.
---------------------- Page: 1 ----------------------
BRIEF HISTORY
The IS0 Recommendation R 582, Rolling Bearings-Tolerances-Metric Series
Bearings-Chamfer Dimension Limits and Maximum Shaft and Housing Fillet Radius,
was drawn up by Technical Committee ISO/TC 4, Rolling Bearings, the Secretariat of
which is held by the Sveriges Standardiseringskommission (SIS).
Work on this question by the Technical Committee began in 1956 and led, in 1961, to
the adoption of a Draft IS0 Recommendation.
In July 1964, this Draft IS0 Recommendation (No. 595) was circulated to all the IS0
Member Bodies for enquiry. It was approved, subject to a few modifications of an editorial
nature, by the following Member Bodies :
Austria Italy Switzerland
Brazil Japan U.A.R.
Netherlands United Kingdom
Chile
Czechoslovakia Poland U.S.A.
Germany Portugal U.S.S.R.
Hungary Romania Yugoslavia
India Spain
Israel Sweden
Two Member Bodies opposed the approval of the Draft:
Canada
France
The Draft IS0 Recommendation was then submitted by correspondence to the IS0
Council, w
...