|
Ref. No.: IS0 / R 545 - 1967 (E)
IS0
STA N DARD I Z AT I O N
I N T ER N AT I O NA L ORGAN I ZAT I O N FOR
IS0 R E CO M M EN DATI O N
R 545
LENGTHS AND TOLERANCE
FOR FILLER RODS, OTHER THAN DRAWN OR EXTRUDED,
FOR WELDING
1st EDITION
January 1967
COPYRIGHT RESERVED
The copyright of IS0 Recommendations and IS0 Standards
belongs to IS0 Member Bodies. Reproduction of these
documents, in any country, may be authorized therefore only
by the national standards organization of that country, being
a member of ISO.
For each individual country the only valid standard is the national standard of that country.
Printed in Switzerland
Also issued in French and Russian. Copies to be obtained through the national standards organizations.
---------------------- Page: 1 ----------------------
BRIEF HISTORY
The IS0 Recommendation R 545, Lengths and Tolerance for Filler Rods, Other than
Drawn or Extruded, .for Welding was drawn up by Technical Committee ISO/TC 44,
Welding, the Secretariat of which is held by the Association française de Normalisation
(AFNOR).
Work on this question by the Technical Committee began
...