|
7 ,
IS0
I N T ER N AT I ON A L O R G A N 12 AT I ON FOR STAND AR D 1 ZATl O N
IS0 RECOMMENDATION
R 737
CONIFEROUS SAWN TIMBER
SIZES - METHODS OF MEASUREMENT
1 st EDIT I ON
May 1968
COPYRIGHT RESERVED
The copyright of IS0 Recommendations and IS0 Standards
belongs to IS0 Member Bodies. Reproduction of these
documents, in any country, may be authorized therefore only
by the national standards organization of that country, being
a member of ISO.
For each individual country the only valid standard is the national standard of that country.
Printed in Switzerland
Also issued in French and Russian. Copies to be obtained through the national standards organizations.
---------------------- Page: 1 ----------------------
,-
BRIEF HISTORY
The IS0 Recommendation R 737, Coniferous sawn timber - Sizes - Methods of measurement,
was drawn up by Technical Committee ISO/TC 55, Sawn timber, the Secretariat of which is held by
the Komitet Standartov, Mer i Izmeritel’nyh Priborov pri Sovete Ministrov S.S.S.R. (COST).
Work on this question by the Technical Committee began in 1956 and led, in 1963, to the
adoption of a Draft IS0 Recommendation.
In November 1965, this Draft IS0 Recommendation (No. 874) was circulated to all the IS0
Member Bodies for enquiry. It was approved, subject to a few modifications of an editorial nature, by
the following Member Bodies :
Australia
India Romania
Belgium
Ireland South Africa, Rep. of
Canada Israel Spain
Czechoslovakia Italy Sweden
Denmark Japan Turkey
Finland Netherlands U.A.R.
France New Zealand United Kingdom
Germany Poland U.S.S.R.
Yugoslavia
Hungary Portugal
One Member Body opposed the approval of the Draft
Austria
The Draft IS0 Recommendation was then submitted by correspondence to the IS0 Council,
which decided, in May 1968, to accept it as an IS0 RECOMMENDATION.
-2-
---------------------- Page: 2 ----------------------
May 1968
IS0 Recommendation R 737
CONIFEROUS SAWN TIMBER
SIZES - METHODS OF MEASUREMENT
1. SCOPE
1.1 This IS0 Recommendation defines methods of measurem
...