|
UDC 62-229.32 : 621.941
IS0
I N T E RN AT I O N A L ORGAN I Z AT I O N FOR STAND A RD IZATl O N
IS0 RECOMMENDATION
R 867
SPINDLE NOSES AND FACE PLATES
BAYONET TYPE
SIZES FOR INTERCHANGEABILITY
METRIC SERIES
1st EDITION
November 1968
COPYRIGHT RESERVED
The copyright of IS0 Recommendations and IS0 Standards
belongs to IS0 Member Bodies. Reproduction of these
documents, in any country, may be authorized therefore only
by the national standards organization of that country, being
a member of ISO.
For each individual country the only valid standard is the national standard of that country.
Printed in Switzerland
Also issued in French and Russian. Copies to be obtained through the national standards organizations.
---------------------- Page: 1 ----------------------
BRIEF HISTORY
The IS0 Recommendation R 867, Spindle noses and face plates - Bayonet type - Sizes for
interchangeability - Metric series, was drawn up by Technical Committee ISO/TC 39, Machine tools,
the Secretariat of which is held by the Association Française de Normalisation (AFNOR).
Work on this question by the Technical Committee began in 1951 and led, in 1965, to the
adoption of a Draft IS0 Recommendation.
In July 1967, this Draft IS0 Recommendation (NO. 1327) was circulated to all the IS0 Member
Bodies for enquiry. It was approved, subject to a few modifications of an editorial nature, by the
following Member Bodies :
India South Africa, Rep. of
Austria
Belgium Iran Spain
Chile Israel Sweden
Czechoslovakia Italy Switzerland
Finland Japan Thailand
Turkey
France Korea, Rep. of
Netherlands U.A.R.
Germany
Greece Pol and United Kingdom
Romania Yugoslavia
Hungary
No Member Body opposed the approval of the Draft.
The Draft IS0 Recommendation was then submitted by correspondence to the IS0 Council,
which decided, in November 1968, to accept it as an IS0 RECOMMENDATION.
CONTENTS
Page
1. Scope . 3
.......................
2. Spindle noses ~ Bayonet type 4
3. Bayonet disc . 6
4. Face plates - Bayonet type . 8
5. Studs and nuts with collars . 10
-2-
---------------------- Page: 2 ----------------------
ISO/R 867-1968 (E)
IS0 Recommendation R 867 November 1968
SPINDLE NOSES AND FACE PLATES
BAYONET TYPE
SIZES FOR INTERCHANGEABI LlTY
METRIC SERIES
.
1. SCOPE
This IS0 Recommendation is the second of a series of IS0 Recommendations specifying the sizes for
interchangeability for lathe spindle noses and face plates and
...