|
TECHNICAL SPECIFICATION
Electronic Signatures and Infrastructures (ESI);
Certificate Profiles;
Part 2: Certificate profile for certificates issued
to natural persons
---------------------- Page: 1 ----------------------
2 ETSI TS 119 412-2 V2.0.16 (2015-07)
Reference
RTS/ESI-0019412-2-TS
Keywords
electronic signature, IP, profile, security,
trust services
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88
Important notice
The present document can be downloaded from:
The present document may be made available in electronic versions and/or in print. The content of any electronic and/or
print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any
existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the
print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
Copyright Notification
No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying
and microfilm except as authorized by written permission of ETSI.
The content of the PDF version shall not be modified without the written authorization of ETSI.
The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2015.
All rights reserved.
TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members.
TM
3GPP and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association.
ETSI
---------------------- Page: 2 ----------------------
3 ETSI TS 119 412-2 V2.0.16 (2015-07)
Contents
Intellectual Property Rights . 4
Foreword . 4
Modal verbs terminology . 4
Introduction . 4
1 Scope . 5
2 References . 5
2.1 Normative references . 5
2.2 Informative references . 6
3 Definitions and abbreviations . 6
3.1 Definitions . 6
3.2 Abbreviations . 6
4 Void . 7
5 General certificate profile requirements . 7
5.1 Generic requirements . 7
5.2 Basic certificate fields . 7
5.2.1 Version . 7
5.2.2 Void . 7
5.2.3 Signature . 7
5.2.4 Issuer . 7
5.2.4.1 Legal person issuers . 7
5.2.4.2 Natural person issuers . 8
5.2.5 Void . 8
5.2.6 Subject . 8
5.2.7 Subject public key info . 8
5.3 Void . 9
5.4 Standard certificate extensions . 9
5.4.1 Authority key identifier . 9
5.4.2 Void . 9
5.4.3 Key usage. 9
5.4.4 Void . 10
5.4.5 Certificate policies . 10
5.4.6 Policy mappings . 10
5.4.7 Subject alternative name . 10
5.4.8 Issuer alternative name . 10
5.4.9 Subject directory attributes . 10
5.4.10 Void . 10
5.4.11 Name constraints . 10
5.4.12 Policy constraints . 10
5.4.13 Extended key usage . 10
5.4.14 CRL distribution points . 10
5.4.15 Inhibit any-policy . 10
5.4.16 Void . 11
5.5 IETF RFC 5280 internet certificate extensions . 11
5.5.1 Authority Information Access. 11
5.5.2 Void . 11
5.6 Void . 11
5.6.1 Void . 11
5.6.2 Void . 11
6 EU qualified certificate requirements . 11
6.1 EU QCStatements. 11
6.2 Certificate policies . 11
History . 12
ETSI
---------------------- Page: 3 ----------------------
4 ETSI TS 119 412-2 V2.0.16 (2015-07)
Intellectual Property Rights
IPRs essential or potentially essential to the present document may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (http://ipr.etsi.org).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Foreword
This Technical Specification (TS) has been produced by ETSI Technical Committee Electronic Signatures and
Infrastructures (ESI).
The present document is part 2 of the multipart deliverable covering the Certificates Profiles. Full details of the entire
series can be found in part 1 [i.4].
The present document was previously published as ETSI TS 102 280.
Modal verbs terminology
In the present document "shall", "shall not", "should", "should not", "may", "need not", "will", "will not", "can" and
"cannot" are to be interpreted as described in clause 3.2 of the ETSI Drafting Rules (Verbal forms for the expression of
provisions).
"must" and "must not" are NOT allowed in ETSI deliverables except when used in direct citation.
Introduction
ITU and ISO issued standards for certification of public keys in ITU X.509 | ISO/IEC 9594-8 [i.3] which are used for
the security of communications and data for a wide range of electronic applications.
Regulation (EU) No 910/2014 [i.5] of the European Parliament and of the Council of 23 July 2014 on electronic
identification and trust services for electronic transactions in the internal market and repealing Directive 1999/93/EC
defines requirements on specific types of certificates named "qualified certificates". Implementation of Directive
1999/93/EC [i.1] and deployment of certificate infrastructures throughout Europe as well as in countries outside of
Europe, have resulted in a variety of certificate implementations for use in public and closed environments, where some
are declared as qualified certificates while others are not.
Applications need support from standardized identity certificates profiles, in particular when applications are used for
electronic signatures, authentication and secure electronic exchange in open environments and international trust
scenarios, but also when certificates are used in local application contexts.
This multi-part document aims to maximize the interoperability of systems issuing and using certificates both in the
European context under the Regulation (EU) No 910/2014 [i.5] and in the wider international environment.
ETSI
---------------------- Page: 4 ----------------------
5 ETSI TS 119 412-2 V2.0.16 (2015-07)
1 Scope
The present document specifies requirements on the content of certificates issued to natural persons. This profile builds
on IETF RFC 5280 [1] for generic profiling of Recommendation ITU-T X.509 / ISO/IEC 9594-8 [i.3].
This profile supports the requirements of EU qualified certificates as specified in the Regulation (EU) No 910/2014 [i.5]
as well as other forms of certificate. The scope of the present document is primary limited to facilitate interoperable
processing and display of certificate information. This profile therefore excludes support for some certificate
information content options, which can be perfectly valid in a local context but which are not regarded as relevant or
suitable for use in widely deployed applications.
The present document focuses on requirements on certificate content. Requirements on decoding and processing rules
are limited to aspects required to process certificate content defined in the present document. Further processing
requirements are only specified for cases where it adds information that is necessary for the sake of interoperability.
Certain applications or protocols impose specific requirements on certificate content. The present document is based on
the assumption that these requirements are adequately defined by the respective application or protocol. It is therefore
outside the scope of the present document to specify such application or protocol specific certificate content.
2 References
2.1 Normative references
References are either specific (identified by date of publication and/or edition number or version number) or
non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the
referenced document (including any amendm
...