|
SIST EN 302 961 V2.1.1:2016
01-junij-2016
3RPRUVNLRVHEQLMDYOMDOQLN]DXVPHUMDQMHSURWLFLOMXNLGHOXMHQDIUHNYHQFL
0+]QDPHQMHQVDPR]DLVNDQMHLQUHãHYDQMH+DUPRQL]LUDQLVWDQGDUGNL]DMHPD
ELVWYHQH]DKWHYHþOHQDGLUHNWLYH(8
Maritime Personal Homing Beacon intended for use on the frequency 121,5 MHz for
search and rescue purposes only - Harmonised Standard covering the essential
requirements of article 3.2 of the Directive 2014/53/EU
Ta slovenski standard je istoveten z: ETSI EN 302 961 V2.1.1 (2016-03)
ICS:
13.200 3UHSUHþHYDQMHQHVUHþLQ Accident and disaster control
NDWDVWURI
33.060.20 Sprejemna in oddajna Receiving and transmitting
oprema equipment
47.020.70 Navigacijska in krmilna Navigation and control
oprema equipment
SIST EN 302 961 V2.1.1:2016 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 302 961 V2.1.1:2016
---------------------- Page: 2 ----------------------
SIST EN 302 961 V2.1.1:2016
ETSI EN 302 961 V2.1.1 (2016-03)
HARMONISED EUROPEAN STANDARD
Maritime Personal Homing Beacon
intended for use on the frequency 121,5 MHz
for search and rescue purposes only;
Harmonised Standard covering the essential requirements
of article 3.2 of the Directive 2014/53/EU
---------------------- Page: 3 ----------------------
SIST EN 302 961 V2.1.1:2016
2 ETSI EN 302 961 V2.1.1 (2016-03)
Reference
REN/ERM-TG26-143
Keywords
harmonised standard, maritime, radio, SAR
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88
Important notice
The present document can be downloaded from:
The present document may be made available in electronic versions and/or in print. The content of any electronic and/or
print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any
existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the
print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
If you find errors in the present document, please send your comment to one of the following services:
Copyright Notification
No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying
and microfilm except as authorized by written permission of ETSI.
The content of the PDF version shall not be modified without the written authorization of ETSI.
The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2016.
All rights reserved.
TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members.
TM
3GPP and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association.
ETSI
---------------------- Page: 4 ----------------------
SIST EN 302 961 V2.1.1:2016
3 ETSI EN 302 961 V2.1.1 (2016-03)
Contents
Intellectual Property Rights . 6
Foreword . 6
Modal verbs terminology . 6
1 Scope . 7
2 References . 7
2.1 Normative references . 7
2.2 Informative references . 7
3 Definitions, symbols and abbreviations . 8
3.1 Definitions . 8
3.2 Symbols . 8
3.3 Abbreviations . 8
4 General requirements . 9
4.1 Construction . 9
4.1.1 Common Requirements . 9
4.1.2 Requirements for operational beacons . 9
4.1.3 Requirements for training beacons . 9
4.1.4 Categories of equipment . 9
4.2 Controls . 10
4.3 Indicators . 10
4.4 Labelling. 10
4.4.1 Common Requirements . 10
4.4.2 Requirements for operational beacons . 10
4.4.3 Requirements for training beacons . 10
4.5 Power source . 10
4.5.1 Battery requirements . 10
4.5.2 Safety precautions . 11
5 Technical requirements . 11
5.1 Radio beacon transmission characteristics . 11
5.2 Radio beacon power source . 11
5.2.1 Battery requirements . 11
6 General conditions of measurement . 11
6.1 Conformity Test frequencies . 11
6.2 Test fixture . 11
6.3 Test conditions power sources and ambient te mperature s . 11
6.3.1 Normal and extreme test conditions. 11
6.3.2 Test power source . 11
6.4 Normal test conditions . 12
6.4.1 Normal temperature and humidity . 12
6.4.2 Normal test voltage . 12
6.5 Extreme test conditions . 12
6.5.1 Extreme temperatures . 12
6.5.2 Extreme test voltages . 12
6.5.2.1 Upper extreme test voltage . 12
6.5.2.2 Lower extreme test voltage . 12
7 Environmental tests . 12
7.1 Introduction . 12
7.2 Procedure . 12
7.3 Performance check . 13
7.4 Drop test . 13
7.4.1 Definition . 13
7.4.2 Test conditions . 13
7.4.3 Method of measurement . 13
7.4.4 Requirements . 13
ETSI
---------------------- Page: 5 ----------------------
SIST EN 302 961 V2.1.1:2016
4 ETSI EN 302 961 V2.1.1 (2016-03)
7.5 Temperature tests . 13
7.5.1 Definition . 13
7.5.2 Dry heat test . 14
7.5.2.1 Method of measurement . 14
7.5.2.2 Requirements . 14
7.5.3 Damp heat test . 14
7.5.3.1 Method of measurement . 14
7.5.3.2 Requirements . 14
7.5.4 Low temperature test . 14
7.5.4.1 Method of measurement . 14
7.5.4.2 Requirements . 14
7.6 Vibration test . 15
7.6.1 Definition . 15
7.6.2 Method of measurement . 15
7.6.3 Requirements . 15
7.7 Corrosion test . 15
7.7.0 Applicability . 15
7.7.1 Definition . 15
7.7.2 Method of measurement . 15
7.7.3 Requirements . 16
7.8 Thermal shock test. 16
7.8.1 Definition . 16
7.8.2 Method of measurement . 16
7.8.3 Requirements . 16
7.9 Buoyancy test . 17
7.9.1 Definition . 17
7.9.2 Method of measurement . 17
7.9.3 Requirements . 17
7.10 Compass safe distance test . 17
7.10.1 Definition . 17
7.10.2 Method of measurement . 17
7.10.3 Requirements . 18
7.11 Solar radiation test . 18
7.11.0 Applicability . 18
7.11.1 Definition . 18
7.11.2 Method of measurement . 18
7.11.3 Requirements . 19
7.12 Oil resistance test. 19
7.12.0 Applicability . 19
7.12.1 Definition . 19
7.12.2 Method of measurement . 19
7.12.3 Requirements . 19
7.13 Protection of the transmitter . 20
7.13.1 Definition . 20
7.13.2 Method of measurement . 20
7.13.3 Requirements . 20
8 Tests on the transmitter . 20
8.1 Frequency error . 20
8.1.1 Definition . 20
8.1.2 Method of measurement . 20
8.1.3 Limit . 20
8.2 Modulation characteristics. 20
8.2.0 General . 20
8.2.1 Modulation sequence . 20
8.2.1.1 Definition . 20
8.2.2 Depth of audio modulation . 21
8.2.2.1 Definition . 21
8.2.3 Audio modulation duty-cycle . 21
8.2.3.1 Definition . 21
8.2.4 Method of measurement . 22
8.2.5 Limits . 22
ETSI
---------------------- Page: 6 ----------------------
SIST EN 302 961 V2.1.1:2016
5 ETSI EN 302 961 V2.1.1 (2016-03)
8.2.6 Audio sweep characteristics . 22
8.2.6.0 General . 22
8.2.6.1 Audio sweep range . 23
8.2.6.2 Audio sweep repetition rate. 23
8.2.6.3 Method of measurement . 23
8.2.6.4 Limits . 23
8.3 Spectral carrier power ratio . 23
8.3.1 Definition . 23
8.3.2 Method of measurement . 23
8.3.3 Limit . 24
8.4 Maximum Effective Radiated Peak Envelope Power (ERPEP) . 24
8.4.1 Definition . 24
8.4.2 Method of measurement under normal test conditions . 24
8.4.3 Method of measurement under extreme test conditions. 25
8.4.4 Limit . 25
8.5 Effective Radiated Power during CW modulation (ERP(CW)) . 25
8.5.1 Definition . 25
8.5.2 Method of measurement under normal test conditions . 25
8.5.3 Limit . 25
8.6 Transmitter spectrum mask . 25
8.6.1 Definition . 25
8.6.2 Method of measurement . 25
8.6.3 Limit . 26
8.7 Radiation produced by operation of the test facility . 26
8.7.1 Definition . 26
8.7.2 Method of measurement . 26
8.7.3 Limit . 27
8.8 Spurious emissions . 27
8.8.1 Definition . 27
8.8.2 Method of measurement . 27
8.8.3 Limit . 27
8.9 Duty Cycle. 27
8.9.1 Definition . 27
8.9.2 Declaration . 27
8.9.3 Limits . 27
9 Testing for compliance with technical requirements . 28
9.1 Environmental conditions for testing . 28
9.2 Interpretation of the measurement results . 28
Annex A (normative): Relationship between the present document and the essential
requirements of Directive 2014/53/EU . 29
History . 30
ETSI
---------------------- Page: 7 ----------------------
SIST EN 302 961 V2.1.1:2016
6 ETSI EN 302 961 V2.1.1 (2016-03)
Intellectual Property Rights
IPRs essential or potentially essential to the present document may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (https://ipr.etsi.org/).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given
...