|
STANDARD
SIST EN 302 617 V2.3.1:2018
ETSI EN 302 617 V2.3.1 (2018-07) Ground-based UHF radio transmitters, receivers and transceivers for the UHF aeronautical mobile service using amplitude modulation; Harmonised Standard for access to radio spectrum
HARMONISED EUROPEAN STANDARD SIST EN 302 617 V2.3.1:2018
ETSI ETSI EN 302 617 V2.3.1 (2018-07) 2
Reference REN/ERM-TGAERO-61 Keywords aeronautical, AM, DSB, harmonised standard, radio, testing, UHF ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00
Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88
Important notice The present document can be downloaded from: The present document may be made available in electronic versions and/or in print. The content of any electronic and/or print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at If you find errors in the present document, please send your comment to one of the following services: Copyright Notification No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm except as authorized by written permission of ETSI. The content of the PDF version shall not be modified without the written authorization of ETSI. The copyright and the foregoing restriction extend to reproduction in all media.
© ETSI 2018. All rights reserved.
DECTTM, PLUGTESTSTM, UMTSTM and the ETSI logo are trademarks of ETSI registered for the benefit of its Members. 3GPPTM and LTETM are trademarks of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. oneM2M logo is protected for the benefit of its Members. GSM and the GSM logo are trademarks registered and owned by the GSM Association. SIST EN 302 617 V2.3.1:2018
ETSI ETSI EN 302 617 V2.3.1 (2018-07) 3 Contents Intellectual Property Rights . 6 Foreword . 6 Modal verbs terminology . 6 1 Scope . 7 2 References . 7 2.1 Normative references . 7 2.2 Informative references . 7 3 Definitions and abbreviations . 8 3.1 Definitions . 8 3.2 Abbreviations . 8 4 General requirements . 9 4.1 Frequency control . 9 4.2 Controls and indicators . 9 4.3 Class of emission and modulation characteristics . 9 4.4 Warm up . 9 4.5 Protection of the transmitter . 9 4.5.1 Definition . 9 4.5.2 Method of measurement . 9 4.5.3 Requirement . 10 5 General conditions of measurement . 10 5.1 Transmitter test signal arrangement . 10 5.1.1 Coaxial termination. 10 5.1.2 Signal sources . 10 5.1.3 Normal test signal . 10 5.2 Receiver test signal arrangement . 10 5.2.1 Test signal sources . 10 5.2.2 Nominal frequency . 10 5.2.3 Normal test signal . 10 5.2.4 Squelch . 10 5.2.5 Normal audio output power . 10 5.2.6 Audio AGC . 10 5.3 Test channels . 11 5.4 Environmental profile . 11 5.5 Test power source . 11 5.6 Normal test conditions . 11 5.6.1 Normal temperature and humidity . 11 5.6.2 Normal power sources . 11 5.6.2.1 Mains voltage and frequency . 11 5.6.2.2 Other power sources . 11 5.7 Extreme test conditions . 12 5.7.1 Extreme temperatures . 12 5.7.2 Extreme values of test power sources . 12 5.7.2.1 Mains voltage . 12 5.7.2.2 Other power sources . 12 5.8 Performance test . 12 5.9 Environmental tests . 12 5.9.1 General . 12 5.9.2 Procedure for tests at extreme temperatures . 13 5.9.3 Temperature tests . 13 5.9.3.1 General . 13 5.9.3.2 High temperature . 13 5.9.3.3 Low temperature . 13 6 Transmitter . 13 SIST EN 302 617 V2.3.1:2018
ETSI ETSI EN 302 617 V2.3.1 (2018-07) 4 6.1 General . 13 6.2 Frequency error . 14 6.2.1 Definition . 14 6.2.2 Method of measurement . 14 6.2.3 Limits . 14 6.3 Carrier power . 14 6.3.1 Definitions . 14 6.3.2 Method of measurement . 14 6.3.3 Limits . 14 6.4 Amplitude modulation characteristic. 15 6.4.1 Modulation depth . 15 6.4.1.1 Definitions . 15 6.4.1.2 Method of measurement . 15 6.4.1.3 Limits . 15 6.4.2 Modulation compression . 15 6.4.2.1 Definition . 15 6.4.2.2 Method of measurement . 15 6.4.2.3 Limits . 16 6.4.3 Amplitude modulation distortion . 16 6.4.3.1 Definition . 16 6.4.3.2 Method of measurement . 16 6.4.3.3 Limits . 16 6.4.4 Audio frequency response . 16 6.4.4.1 Definition . 16 6.4.4.2 Method of measurement . 16 6.4.4.3 Limits . 16 6.5 Adjacent channel power . 17 6.5.1 Definition . 17 6.5.2 Measurement. 17 6.5.3 Limits . 17 6.6 Broadband noise . 17 6.6.1 Definition . 17 6.6.2 Method of measurement . 18 6.6.3 Limit . 18 6.7 Conducted spurious emissions (TX). 19 6.7.1 Definition . 19 6.7.2 Method of measurement . 19 6.7.3 Limits . 19 6.8 Intermodulation attenuation. 19 6.8.1 Definition . 19 6.8.2 Method of measurement . 20 6.8.3 Limits . 20 6.9 RF power attack time and release time . 21 6.9.1 Definitions . 21 6.9.2 Method of measurement . 21 6.9.2.1 Attack time . 21 6.9.2.2 Release time . 21 6.9.3 Limits . 22 6.10 Keying Transient frequency behaviour of the transmitter . 22 6.10.1 Definition . 22 6.10.2 Method of measurement . 22 6.10.3 Limits . 23 6.11 Cabinet Radiation (TX) . 23 7 Receiver . 23 7.1 Sensitivity . 23 7.1.1 Definition . 23 7.1.2 Method of measurement . 23 7.1.3 Limits . 23 7.2 Effective acceptance bandwidth . 23 7.2.1 Definition . 23 7.2.2 Method of measurement . 24 SIST EN 302 617 V2.3.1:2018
ETSI ETSI EN 302 617 V2.3.1 (2018-07) 5 7.2.3 Limits . 24 7.3 Adjacent channel rejection . 24 7.3.1 Definition . 24 7.3.2 Method of measurement . 24 7.3.3 Limits . 25 7.4 Spurious response rejection . 25 7.4.1 Definition . 25 7.4.2 Introduction to the method of measurement . 25 7.4.3 Method of search of the limited frequency range . 25 7.4.4 Method of measurement . 26 7.4.5 Limit . 26 7.5 Intermodulation response rejection . 26 7.5.1 Definition . 26 7.5.2 Method of measurement . 26 7.5.3 Limit . 27 7.6 Blocking or desensitization . 27 7.6.1 Definition . 27 7.6.2 Method of measurement . 27 7.6.3 Limit . 28 7.7 Conducted spurious emissions . 28 7.7.1 Definition . 28 7.7.2 Method of measuring the power level . 28 7.7.3 Limits . 28 7.8 Cross modulation rejection . 29 7.8.1 Definition . 29 7.8.2 Method of measurement . 29 7.8.3 Limits . 29 7.9 Receiver dynamic range . 29 7.9.1 Definition . 29 7.9.2 Method of measurement . 29 7.9.3 Limit . 30 7.10 Cabinet Radiation (RX) . 30 8 Testing for compliance with technical requirements . 30 8.1 Environmental conditions for testing . 30 8.2 Interpretation of the measurement results . 30 Annex A (informative): Relationship between the present document and the essential requirements of Directive 2014/53/EU . 32 Annex B (normative): Specification for adjacent channel power measurement arrangements . 34 B.1 Power measuring receiver specification . 34 B.1.1 General . 34 B.1.2 IF filter . 34 B.1.3 Attenuation indicator . 35 B.1.4 RMS value indicator . 35 B.1.5 Oscillator and amplifier . 35 Annex C (informative): Auxiliary cables . 36 Annex D (informative): Change history . 37 History . 38
SIST EN 302 617 V2.3.1:2018
ETSI ETSI EN 302 617 V2.3.1 (2018-07) 6 Intellectual Property Rights Essential patents IPRs essential or potentially essential to normative deliverables may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards", which is available from t
...