|
TECHNICAL SPECIFICATION
Digital cellular telecommunications system (Phase 2+) (GSM);
GSM/EDGE Radio subsystem link control
(3GPP TS 45.008 version 13.8.0 Release 13)
R
GLOBAL SYSTEM FOR
MOBILE COMMUNICATIONS
---------------------- Page: 1 ----------------------
3GPP TS 45.008 version 13.8.0 Release 13 1 ETSI TS 145 008 V13.8.0 (2018-10)
Reference
RTS/TSGR-0645008vd80
Keywords
GSM
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88
Important notice
The present document can be downloaded from:
The present document may be made available in electronic versions and/or in print. The content of any electronic and/or
print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any
existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the
print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
If you find errors in the present document, please send your comment to one of the following services:
Copyright Notification
No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying
and microfilm except as authorized by written permission of ETSI.
The content of the PDF version shall not be modified without the written authorization of ETSI.
The copyright and the foregoing restriction extend to reproduction in all media.
© ETSI 2018.
All rights reserved.
TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are trademarks of ETSI registered for the benefit of its Members.
TM TM
3GPP and LTE are trademarks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
oneM2M logo is protected for the benefit of its Members.
GSM and the GSM logo are trademarks registered and owned by the GSM Association.
ETSI
---------------------- Page: 2 ----------------------
3GPP TS 45.008 version 13.8.0 Release 13 2 ETSI TS 145 008 V13.8.0 (2018-10)
Intellectual Property Rights
Essential patents
IPRs essential or potentially essential to normative deliverables may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (https://ipr.etsi.org/).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Trademarks
The present document may include trademarks and/or tradenames which are asserted and/or registered by their owners.
ETSI claims no ownership of these except for any which are indicated as being the property of ETSI, and conveys no
right to use or reproduce any trademark and/or tradename. Mention of those trademarks in the present document does
not constitute an endorsement by ETSI of products, services or organizations associated with those trademarks.
Foreword
This Technical Specification (TS) has been produced by ETSI 3rd Generation Partnership Project (3GPP).
The present document may refer to technical specifications or reports using their 3GPP identities, UMTS identities or
GSM identities. These should be interpreted as being references to the corresponding ETSI deliverables.
The cross reference between GSM, UMTS, 3GPP and ETSI identities can be found under
.
Modal verbs terminology
In the present document "shall", "shall not", "should", "should not", "may", "need not", "will", "will not", "can" and
"cannot" are to be interpreted as described in clause 3.2 of the ETSI Drafting Rules (Verbal forms for the expression of
provisions).
"must" and "must not" are NOT allowed in ETSI deliverables except when used in direct citation.
ETSI
---------------------- Page: 3 ----------------------
3GPP TS 45.008 version 13.8.0 Release 13 3 ETSI TS 145 008 V13.8.0 (2018-10)
Contents
Intellectual Property Rights . 2
Foreword . 2
Modal verbs terminology . 2
Foreword . 8
1 Scope . 9
1.1 References . 9
1.2 Abbreviations . 11
1.3 Definitions . 11
1.4 Restrictions . 11
2 General . 11
3 Handover . 13
3.1 Overall process . 13
3.2 MS measurement procedure . 13
3.3 BSS measurement procedure . 13
3.4 Strategy . 13
4 RF power control . 14
4.1 Overall process . 14
4.2 MS implementation . 14
4.2.1 General . 14
4.2.2 (EC-)RACH . 15
4.2.2.1 Random access procedure when EC operation is not enabled . 15
4.2.2.2 Random access procedure when EC operation is enabled . 16
4.3 MS power control range . 16
4.4 BSS implementation . 17
4.4.1 VAMOS subchannel power control for BSS in downlink . 17
4.5 BSS power control range . 17
4.6 Strategy . 17
4.7 Timing . 17
4.7.1 Normal Power Control . 17
4.7.2 Fast Power Control . 18
4.7.3 Enhanced Power Control . 18
4.8 Dedicated channels used for a voice group call or voice broadcast. 18
5 Radio link failure . 19
5.1 Criterion . 19
5.2 MS procedure . 19
5.3 BSS procedure . 20
6 Idle mode tasks . 20
6.1 Introduction . 20
6.2 Measurements for normal cell selection . 21
6.3 Measurements for stored list cell selection . 22
6.4 Criteria for cell selection and reselection . 22
6.4.1 C1 path loss criterion . 22
6.4.2 C2 reselection criterion . 23
6.4.3 C4 criteria . 25
6.4.4 Disabling of EC operation . 25
6.5 Downlink signalling failure . 25
6.6 Measurements for Cell Reselection . 26
6.6.0 General . 26
6.6.1 Monitoring of received signal level and BCCH data . 26
6.6.1.1 Applicability. 26
6.6.1.2 Monitoring of received signal level . 26
6.6.1.3 Monitoring of BCCH data and BSIC decoding . 27
6.6.1.4 Determination of available PLMNs . 27
ETSI
---------------------- Page: 4 ----------------------
3GPP TS 45.008 version 13.8.0 Release 13 4 ETSI TS 145 008 V13.8.0 (2018-10)
6.6.1.5 Requirements for synchronization and reading of BCCH data . 27
6.6.1a Reduced Monitoring of received signal level and (EC-)BCCH data . 27
6.6.1a.1 General . 27
6.6.1a.2 Monitoring of the serving cell . 27
6.6.1a.3 Criteria for triggering measurements for cell re-selection. 28
6.6.1a.4 Monitoring of non-serving cells . 29
6.6.2 Path loss criteria and timings for cell re-selection . 29
6.6.3 Cell reselection algorithm for SoLSA . 30
6.6.4 Measurements on cells of other radio access technologies . 30
6.6.5 Algorithm for cell re-selection from GSM to UTRAN based on cell ranking . 35
6.6.6 Algorithm for inter-RAT cell re-selection based on priority information . 36
6.6.7 Cell selection and re-selection to CSG cells and hybrid cells . 39
6.6.7.1 Cell re-selection to CSG cells . 39
6.6.7.1a Cell re-selection to hybrid cells . 40
6.6.7.2 Manual CSG ID selection . 40
6.7 Release of TCH, SDCCH and DBPSCH . 40
6.7.1 Normal case . 40
6.7.2 Call re-establishment . 41
6.8 Abnormal cases and emergency calls . 41
6.9 RLA_EC signal level and SLA measurements . 42
6.9.1 General . 42
6.9.2 Physical parameters . 42
6.9.3 Statistical parameter . 42
6.9.4 Accuracy requirements . 43
6.9.5 Void . 43
6.9a RLA_GC signal level measurements . 43
6.9a.1 General . 43
6.9a.2 Physical parameter . 43
6.9a.3 Statistical parameter . 43
6.9a.4 Accuracy requirements . 43
6.10 Coverage class selection for EC-GSM-IoT . 43
6.10.1 General . 43
6.10.2 Downlink coverage class selection . 43
6.10.3 Uplink coverage class selection . 44
6.10.4 Coverage class adaptation for EC-CCCH . 45
6.10.5 Downlink coverage class update . 45
7 Network pre-requisites . 46
7.1 BCCH carriers . 46
7.2 Identification of surrounding BSS . 47
7.2.1 General . 47
7.2.2 Identification of surrounding BSS for handover measurements . 48
7.3 Handover measurements on other radio access technologies . 49
7.4 Handover measurements on UTRAN CSG cells and hybrid cells . 52
8 Radio link measurements . 53
8.1 Signal level . 53
8.1.1 General . 53
8.1.2 Physical parameter . 53
8.1.3 Statistical parameters . 54
8.1.4 Range of parameter . 54
8.1.5 Measurement quantity for other radio access technologies . 55
8.1.5.1 UTRAN FDD . 55
8.1.5.2 UTRAN TDD . 55
8.1.5.3 cdma2000 . 55
8.1.5.4 E-UTRAN FDD . 55
8.1.5.5 E-UTRAN TDD . 57
8.2 Signal quality . 57
8.2.1 General . 57
8.2.2 Physical parameter . 57
8.2.3 Statistical parameters . 57
8.2.3.1 RXQUAL . 57
ETSI
---------------------- Page: 5 ----------------------
3GPP TS 45.008 version 13.8.0 Release 13 5 ETSI TS 145 008 V13.8.0 (2018-10)
8.2.3.2 MEAN_ BEP and CV_BEP . 58
8.2.4 Range of parameter RXQUAL . 59
8.2.5 Range of parameters MEAN_BEP and CV_BEP . 60
8.3 Aspects of discontinuous transmission (DTX) . 64
8.4 Measurement reporting . 65
8.4.1 Measurement reporting for the MS . 65
8.4.1a Measurement reporting for the MS in FPC mode . 67
8.4.1b Measurement reporting for the MS in EPC mode . 67
8.4.2 Measurement reporting for the MS on a SDCCH . 68
8.4.3 Additional cell reporting requirements for multi band MS . 68
8.4.4 Common aspects for the MS on a TCH, a SDCCH or a DBPSCH . 69
8.4.5 Measurement reporting for the BSS . 69
8.4.6 Extended measurement reporting . 69
8.4.7 Additional cell reporting requirements for multi-RAT MS . 70
8.4.8 Enhanced Measurement Reporting . 71
8.4.8.1 Reporting Priority . 72
8.4.8.2 Measurement Reporting . 73
8.4.8.3 NBR_RCVD_BLOCKS for FLO . 74
8.4.9 Requirements for measurement and reporting of CSG cells and hybrid cells . 74
8.5 Absolute MS-BTS distance . 75
8.5.1 General . 75
8.5.2 Physical parameter . 75
9 Control parameters . 76
10 GPRS mode tasks . 89
10.1 Cell Re-selection . 89
10.1.0 General . 89
10.1.1 Monitoring the received signal level and PBCCH data . 90
10.1.1.0 General . 90
10.1.1.1 Packet idle mode or MAC-Idle state . 90
10.1.1.2 Packet transfer mode or MAC-Shared state . 91
10.1.1.2a Broadcast/multicast receive mode . 92
10.1.1.3 Monitoring cells of other radio access technologies . 93
10.1.2 Cell Re-selection Criteria . 97
10.1.3 Cell Re-selection Algorithm . 98
10.1.3.1 Abnormal cell reselection . 99
10.1.3.2 Algorithm for cell re-selection from GSM to UTRAN based on cell ranking . 100
10.1.3.3 Algorithm for inter-RAT cell re-selection based on priority information . 101
10.1.3.4 Cell selection and re-selection to CSG cells and hybrid cells . 101
10.1.4 Network controlled Cell re-selection . 101
10.1.4.1 Measurement reporting . 102
10.1.4.2 Cell re-selection command . 106
10.1.4.3 Exceptional cases . 106
10.1a Measurement and Reporting of CSG Cells and hybrid cells . 106
10.2 RF Power Control . 107
10.2.1 MS output power .
...