|
TECHNICAL SPECIFICATION
Smart Cards;
UICC - Contactless Front-end (CLF) Interface;
Host Controller Interface (HCI)
(Release 11)
---------------------- Page: 1 ----------------------
Release 11 2 ETSI TS 102 622 V11.4.0 (2018-12)
Reference
RTS/SCP-THCIvc40
Keywords
smart card
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88
Important notice
The present document can be downloaded from:
The present document may be made available in electronic versions and/or in print. The content of any electronic and/or
print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any
existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the
print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
If you find errors in the present document, please send your comment to one of the following services:
Copyright Notification
No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying
and microfilm except as authorized by written permission of ETSI.
The content of the PDF version shall not be modified without the written authorization of ETSI.
The copyright and the foregoing restriction extend to reproduction in all media.
© ETSI 2018.
All rights reserved.
TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are trademarks of ETSI registered for the benefit of its Members.
TM TM
3GPP and LTE are trademarks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
oneM2M™ logo is a trademark of ETSI registered for the benefit of its Members and
of the oneM2M Partners.
GSM and the GSM logo are trademarks registered and owned by the GSM Association.
ETSI
---------------------- Page: 2 ----------------------
Release 11 3 ETSI TS 102 622 V11.4.0 (2018-12)
Contents
Intellectual Property Rights . 6
Foreword . 6
Modal verbs terminology . 6
1 Scope . 7
2 References . 7
2.1 Normative references . 7
2.2 Informative references . 8
3 Definition of terms, symbols and abbreviations . 8
3.1 Terms . 8
3.2 Symbols . 8
3.3 Abbreviations . 8
3.4 Void . 9
3A Coding conventions . 9
4 HCI architecture . 9
4.1 Overview . 9
4.2 Hosts . 10
4.3 Gates . 10
4.4 Pipes . 11
4.5 Registries . 12
5 HCP . 13
5.1 HCP packets . 13
5.2 HCP message structure . 13
5.3 Message fragmentation . 14
6 Instructions . 15
6.0 Foreword . 15
6.1 Commands . 15
6.1.1 Overview . 15
6.1.2 Generic commands . 16
6.1.2.1 ANY_SET_PARAMETER . 16
6.1.2.2 ANY_GET_PARAMETER . 16
6.1.2.3 ANY_OPEN_PIPE . 16
6.1.2.4 ANY_CLOSE_PIPE . 17
6.1.3 Administration commands . 17
6.1.3.1 ADM_CREATE_PIPE . 17
6.1.3.2 ADM_NOTIFY_PIPE_CREATED . 17
6.1.3.3 ADM_DELETE_PIPE . 18
6.1.3.4 ADM_NOTIFY_PIPE_DELETED . 18
6.1.3.5 ADM_CLEAR_ALL_PIPE . 18
6.1.3.6 ADM_NOTIFY_ALL_PIPE_CLEARED . 18
6.2 Responses . 19
6.3 Events . 20
7 GATES . 20
7.0 Generic gate events and command support . 20
7.1 Management gates . 22
7.1.1 Administration gates . 22
7.1.1.1 Host controller administration gate . 22
7.1.1.2 Host administration gate . 22
7.1.2 Link management gate . 23
7.1.2.1 Host controller link management gate. 23
7.1.2.2 Host link management gate . 23
7.1.3 Identity management gate . 24
7.1.4 Loop back gate . 24
ETSI
---------------------- Page: 3 ----------------------
Release 11 4 ETSI TS 102 622 V11.4.0 (2018-12)
7.2 Generic gates . 24
8 HCI procedures . 25
8.1 Pipe management . 25
8.1.1 Pipe creation . 25
8.1.2 Pipe deletion . 27
8.1.3 Clear all Pipes . 28
8.2 Registry access . 28
8.3 Host and Gate discovery . 29
8.4 Session initialization. 30
8.5 Loop back testing . 31
9 Contactless card emulation . 32
9.1 Overview . 32
9.2 Void . 34
9.3 Gates . 34
9.3.1 Void . 34
9.3.2 Identity management gate . 34
9.3.3 Card RF gates . 34
9.3.3.1 Overview . 34
9.3.3.2 Commands . 34
9.3.3.3 Events . 34
9.3.3.3.0 Supported events . 34
9.3.3.3.1 EVT_SEND_DATA . 35
9.3.3.4 Registry . 35
9.3.3.4.0 Registries persistence . 35
9.3.3.4.1 RF technology type A . 35
9.3.3.4.2 RF technology type B . 37
9.3.3.4.3 RF technology type B' . 38
9.3.3.4.4 RF technology Type F (ISO/IEC 18092 212 kbps/424 kbps card emulation only) . 38
9.3.4 Card application gates . 39
9.3.4.1 Overview . 39
9.3.4.2 Commands . 39
9.3.4.3 Events . 39
9.3.4.3.0 Supported events . 39
9.3.4.3.1 EVT_FIELD_ON . 39
9.3.4.3.2 EVT_CARD_DEACTIVATED . 40
9.3.4.3.3 EVT_CARD_ACTIVATED . 40
9.3.4.3.4 EVT_FIELD_OFF . 40
9.3.4.3.5 EVT_SEND_DATA . 40
9.3.4.4 Registry . 40
9.4 Procedures . 41
9.4.0 Overview and basic rule . 41
9.4.1 Use of contactless card application . 41
9.4.2 Non ISO/IEC 14443-4 type A applications . 42
9.4.3 Type B' RF technology . 42
9.4.4 Type F RF technology . 42
9.4.5 Update RF technology settings . 43
9.4.6 Identity check . 43
10 Contactless reader . 44
10.1 Overview . 44
10.2 Reader RF gates . 45
10.2.1 Overview . 45
10.2.2 Command . 45
10.2.2.1 WR_XCHG_DATA . 45
10.2.3 Registries . 46
10.2.3.1 Type A reader RF gate . 46
10.2.3.2 Type B reader RF gate . 48
10.2.4 Events . 49
10.2.4.0 Supported events . 49
10.2.4.1 EVT_READER_REQUESTED . 49
10.2.4.2 EVT_END_OPERATION . 49
ETSI
---------------------- Page: 4 ----------------------
Release 11 5 ETSI TS 102 622 V11.4.0 (2018-12)
10.2.5 Responses . 49
10.3 Reader application gates . 49
10.3.1 Overview . 49
10.3.2 Command . 49
10.3.3 Registry . 49
10.3.4 Events . 50
10.3.4.0 Supported events . 50
10.3.4.1 EVT_TARGET_DISCOVERED . 50
10.3.4.2 EVT_READER_STATUS . 50
10.4 Procedures . 51
10.4.0 Introduction. 51
10.4.1 Use of contactless reader application . 51
10.4.2 Contactless reader not available . 52
10.4.3 Error management. 53
11 Connectivity . 53
11.1 Overview . 53
11.2 Connectivity gate . 54
11.2.0 Overview . 54
11.2.1 Commands . 54
11.2.1.1 PRO_HOST_REQUEST . 54
11.2.2 Events . 54
11.2.2.0 Supported events . 54
11.2.2.1 EVT_CONNECTIVITY . 54
11.2.2.2 Void. 55
11.2.2.3 EVT_OPERATION_ENDED . 55
11.2.2.4 EVT_TRANSACTION . 55
11.2.3 Registry . 55
11.3 Connectivity application gate . 55
11.3.0 Overview . 55
11.3.1 Commands . 55
11.3.2 Events . 55
11.3.2.1 EVT_STANDBY . 56
11.3.3 Registry . 56
11.4 Procedures . 56
11.4.1 Use of connectivity gate . 56
Annex A (normative): State diagram for contactless reader mode . 57
Annex B (informative): Change history . 58
History . 60
ETSI
---------------------- Page: 5 ----------------------
Release 11 6 ETSI TS 102 622 V11.4.0 (2018-12)
Intellectual Property Rights
Essential patents
IPRs essential or potentially essential to normative deliverables may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (https://ipr.etsi.org/).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Trademarks
The present document may include trademarks and/or tradenames which are asserted and/or registered by their owners.
ETSI claims no ownership of these except for any which are indicated as being the property of ETSI, and conveys no
right to use or reproduce any trademark and/or tradename. Mention of those trademarks in the present document does
not constitute an endorsement by ETSI of products, services or organizations associated with those trademarks.
Foreword
This Technical Specification (TS) has been produced by ETSI Technical Committee Smart Card Platform (SCP).
The contents of the present document are subject to continuing work within TC SCP and may change following formal
TC SCP approval. If TC SCP modifies the contents of the present document, it will then be republished by ETSI with
an identifying change of release date and an increase in version number as follows:
Version x.y.z
where:
x the first digit:
0 early working draft;
1 presented to TC SCP for information;
2 presented to TC SCP for approval;
3 or greater indicates TC SCP approved document under change control.
Y the second digit is incremented for all changes of substance, i.e. technical enhancements, corrections,
updates, etc.
z the third digit is incremented when editorial only changes have been incorporated in the document.
Modal verbs terminology
In the present document "shall", "shall not", "should", "should not", "may", "need not", "will", "will not", "can" and
"cannot" are to be interpreted as described in clause 3.2 of the ETSI Drafting Rules (Verbal forms for the expression of
provisions).
"must" and "must not" are NOT allowed in ETSI deliverables except when used in direct citation.
ETSI
---------------------- Page: 6 ----------------------
Release 11 7 ETSI TS 102 622 V11.4.0 (2018-12)
1 Scope
The present document specifies a logical interface that enables contactless applications hosted on the UICC. The present
document covers the configuration where the one host is embedded in the UICC which is conne
...