|
TECHNICAL SPECIFICATION
Universal Mobile Telecommunications System (UMTS);
LTE;
Internet Protocol (IP) multimedia call control protocol based on
Session Initiation Protocol (SIP)
and Session Description Protocol (SDP);
User Equipment (UE) conformance specification;
Part 1: Protocol conformance specification
(3GPP TS 34.229-1 version 14.5.0 Release 14)
---------------------- Page: 1 ----------------------
3GPP TS 34.229-1 version 14.5.0 Release 14 1 ETSI TS 134 229-1 V14.5.0 (2018-12)
Reference
RTS/TSGR-0534229-1ve50
Keywords
LTE,UMTS
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88
Important notice
The present document can be downloaded from:
The present document may be made available in electronic versions and/or in print. The content of any electronic and/or
print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any
existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the
print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
If you find errors in the present document, please send your comment to one of the following services:
Copyright Notification
No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying
and microfilm except as authorized by written permission of ETSI.
The content of the PDF version shall not be modified without the written authorization of ETSI.
The copyright and the foregoing restriction extend to reproduction in all media.
© ETSI 2018.
All rights reserved.
TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are trademarks of ETSI registered for the benefit of its Members.
TM TM
3GPP and LTE are trademarks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
oneM2M™ logo is a trademark of ETSI registered for the benefit of its Members and
of the oneM2M Partners
GSM and the GSM logo are trademarks registered and owned by the GSM Association.
ETSI
---------------------- Page: 2 ----------------------
3GPP TS 34.229-1 version 14.5.0 Release 14 2 ETSI TS 134 229-1 V14.5.0 (2018-12)
Intellectual Property Rights
Essential patents
IPRs essential or potentially essential to normative deliverables may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (https://ipr.etsi.org/).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Trademarks
The present document may include trademarks and/or tradenames which are asserted and/or registered by their owners.
ETSI claims no ownership of these except for any which are indicated as being the property of ETSI, and conveys no
right to use or reproduce any trademark and/or tradename. Mention of those trademarks in the present document does
not constitute an endorsement by ETSI of products, services or organizations associated with those trademarks.
Foreword
This Technical Specification (TS) has been produced by ETSI 3rd Generation Partnership Project (3GPP).
The present document may refer to technical specifications or reports using their 3GPP identities, UMTS identities or
GSM identities. These should be interpreted as being references to the corresponding ETSI deliverables.
The cross reference between GSM, UMTS, 3GPP and ETSI identities can be found under
.
Modal verbs terminology
In the present document "shall", "shall not", "should", "should not", "may", "need not", "will", "will not", "can" and
"cannot" are to be interpreted as described in clause 3.2 of the ETSI Drafting Rules (Verbal forms for the expression of
provisions).
"must" and "must not" are NOT allowed in ETSI deliverables except when used in direct citation.
ETSI
---------------------- Page: 3 ----------------------
3GPP TS 34.229-1 version 14.5.0 Release 14 3 ETSI TS 134 229-1 V14.5.0 (2018-12)
Contents
Intellectual Property Rights . 2
Foreword . 2
Modal verbs terminology . 2
Foreword . 30
Introduction . 30
1 Scope . 31
2 References . 31
3 Definitions, symbols and abbreviations . 37
3.1 Definitions . 37
3.2 Symbols . 37
3.3 Abbreviations . 37
4 Overview . 38
4.1 Test Methodology. 38
4.1.1 Testing of optional functions and procedures . 38
4.2 Implicit Testing . 38
4.3 Conformance Requirements . 38
5 Reference Conditions . 38
5.1 Generic setup procedures . 38
5.2 Transport protocols applied . 38
6 PDP Context Activation . 38
6.1 General Purpose PDP Context Establishment . 38
6.2 General Purpose PDP Context Establishment (UE Requests for a Dedicated PDP Context). 39
6.2.1 Definition . 39
6.2.2 Conformance requirement . 39
6.2.3 Test purpose . 39
6.2.4 Method of test . 40
6.2.5 Test requirements . 41
6.3 Dedicated PDP Context Establishment . 41
6.3.1 Definition . 41
6.3.2 Conformance requirement . 41
6.3.3 Test purpose . 42
6.3.4 Method of test . 42
6.3.5 Test requirements . 44
7 P-CSCF Discovery . 44
7.1 P-CSCF Discovery via PDP Context. 44
7.1.1 Definition . 44
7.1.2 Conformance requirement . 44
7.1.3 Test purpose . 46
7.1.4 Method of test . 46
7.1.5 Test requirements . 48
7.2 P-CSCF Discovery via DHCP – IPv4 . 48
7.2.1 Definition . 48
7.2.2 Conformance requirement . 48
7.2.3 Test purpose . 49
7.2.4 Method of test . 49
7.2.5 Test requirements . 52
7.3 P-CSCF Discovery via DHCP – IPv4 (UE Requests P-CSCF discovery via PCO) . 52
7.3.1 Definition . 52
7.3.2 Conformance requirement . 52
7.3.3 Test purpose . 54
7.3.4 Method of test . 54
7.3.5 Test requirements . 57
ETSI
---------------------- Page: 4 ----------------------
3GPP TS 34.229-1 version 14.5.0 Release 14 4 ETSI TS 134 229-1 V14.5.0 (2018-12)
7.4 P-CSCF Discovery by DHCP - IPv6 . 57
7.4.1 Definition . 57
7.4.2 Conformance requirement . 58
7.4.3 Test purpose . 58
7.4.4 Method of test . 59
7.4.5 Test requirements . 63
7.5 P-CSCF Discovery by DHCP-IPv6 (UE Requests P-CSCF discovery by PCO) . 63
7.5.1 Definition . 63
7.5.2 Conformance requirement . 63
7.5.3 Test purpose . 65
7.5.4 Method of test . 65
7.5.5 Test requirements . 70
7.6 P-CSCF Discovery by DHCP – IPv6 (UE does not Request P-CSCF discovery by PCO, SS includes P-
CSCF Address(es) in PCO) . 70
7.6.1 Definition . 70
7.6.2 Conformance requirement . 70
7.6.3 Test purpose . 71
7.6.4 Method of test . 71
7.6.5 Test requirements . 76
7.7 Void . 76
7.8 Void . 76
7.9 Void . 76
8 Registration . 76
8.1 Initial registration . 76
8.1.1 Definition . 76
8.1.2 Conformance requirement . 77
8.1.3 Test purpose . 88
8.1.4 Method of test . 89
8.1.5 Test requirements . 89
8.2 User Initiated Re-Registration . 90
8.2.1 Definition . 90
8.2.2 Conformance requirement . 90
8.2.3 Test purpose . 92
8.2.4 Method of test . 93
8.2.5 Test requirements . 95
8.3 Mobile Initiated Deregistration . 95
8.3.1 Definition . 95
8.3.2 Conformance requirement . 95
8.3.3 Test purpose . 97
8.3.4 Method of test . 97
8.3.5 Test Requirements . 98
8.4 Invalid behaviour- 423 Interval too brief . 98
8.4.1 Definition . 98
8.4.2 Conformance requirement . 98
8.4.3 Test purpose . 98
8.4.4 Method of test . 98
8.4.5 Test requirements . 100
8.5 to 8.9 Void . 100
8.10 Initial registration using GIBA . 100
8.10.1 Definition . 100
8.10.2 Conformance requirement . 100
8.10.3 Test purpose . 105
8.10.4 Method of test . 105
8.10.5 Test requirements . 106
8.11 Initial registration using IMS AKA and GIBA against a network with GIBA support only . 106
8.11.1 Definition . 106
8.11.2 Conformance requirement . 106
8.11.3 Test purpose . 112
8.11.4 Method of test . 112
8.11.5 Test requirements . 113
8.12 User initiated re-registration using GIBA . 114
ETSI
---------------------- Page: 5 ----------------------
3GPP TS 34.229-1 version 14.5.0 Release 14 5 ETSI TS 134 229-1 V14.5.0 (2018-12)
8.12.1 Definition . 114
8.12.2 Conformance requirement . 114
8.12.3 Test purpose . 115
8.12.4 Method of test . 116
8.12.5 Test requirements . 117
8.13 User initiated de-registration using GIBA . 117
8.13.1 Definition . 117
8.13.2 Conformance requirement . 117
8.13.3 Test purpose . 119
8.13.4 Method of test . 119
8.13.5 Test requirements . 119
8.14 Initial registration for three implicit registration sets . 120
8.14.1 Definition . 120
8.14.2 Conformance requirement . 120
8.14.3 Test purpose . 120
8.14.4 Method of test . 120
8.14.5 Test requirements . 123
8.15 Refresh for ISIM parameters . 123
8.15.1 Definition . 123
8.15.2 Conformance requirement . 123
8.15.3 Test purpose . 123
8.15.4 Method of test . 124
8.15.5 Test requirements . 125
8.16 User initiated re-registration - 423 Interval Too Brief . 125
8.16.1 Definition . 125
8.16.2 Conformance requirement . 126
8.16.3 Test purpose . 126
8.16.4 Method of test . 126
8.16.5 Test requirements . 128
9 Authentication . 128
9.1 Invalid Behaviour – MAC Parameter Invalid . 128
9.1.1 Definition . 128
9.1.2 Conformance requirement . 128
9.1.3 Test purpose . 129
9.1.4 Method of test . 129
9.1.5 Test requirements . 131
9.2 Invalid Behaviour – SQN out of range . 131
9.2.1 Definition .
...